Firstly I am a new member and thank you for all of the great info! I have a stock PA-12 other than droop tips. After a few flights I noticed that the right wing was low. I assumed it needed bungee cords and ordered the 1280hd from Univair. After I got things opened up for bungees there really wasn’t
Much difference in the gear position or bungee cord condition. Once leveled following the alternate method ( I couldn’t find the plumb bob markings) there is a 4 inch difference floor to wingtip measurement. So I looked at the dihedral and it is off. Digital level 0.2 right and 1.5 degrees left.
when I looked at the strut attachments the threads showing on the right ( the low wing) was 6
And on the left about one. My question is if this a normal discrepancy and do I have room to adjust the dihedral....or what other info might help establish the problem. Airframe TT about 10,000 Thanks
Much difference in the gear position or bungee cord condition. Once leveled following the alternate method ( I couldn’t find the plumb bob markings) there is a 4 inch difference floor to wingtip measurement. So I looked at the dihedral and it is off. Digital level 0.2 right and 1.5 degrees left.
when I looked at the strut attachments the threads showing on the right ( the low wing) was 6
And on the left about one. My question is if this a normal discrepancy and do I have room to adjust the dihedral....or what other info might help establish the problem. Airframe TT about 10,000 Thanks