I need the fixed pitch cylinder that fits inside the hub to set the phase angle on the exterior hubs and props.
Does any one have this little cylinder that they would part with.
If not part with , then could you take measurements so I can have one machined.
I have a F200 flat flange hub assembly that I am working on and need this item.
Trial and error on the phase angle would ruin the hub of the prop as the props have to be drilled once phase is set.
My understanding is that there is very little area in which to drill.
Any help would be appreciated.
Thanks, Ken
Does any one have this little cylinder that they would part with.
If not part with , then could you take measurements so I can have one machined.
I have a F200 flat flange hub assembly that I am working on and need this item.
Trial and error on the phase angle would ruin the hub of the prop as the props have to be drilled once phase is set.
My understanding is that there is very little area in which to drill.
Any help would be appreciated.
Thanks, Ken