Floor board scuff plates

[MEM-PA12]

Are most folks making their own floor board scuff plates that I see aft of the pedals? Anyone know of a source where they can be bought already finished? Thx

[wireweinie]

Not sure what finish you need but they're just scuff plates. By nature 'finish' would be short lived at best. make them as big or as small as you need. Aluminum, stainless, or even kydex or nylon. If you don't want or can't use screws to hold them in place, glue them down.

Web

[mike mcs repair]

I Don’t install them since I use aluminum for the floor boards


Sent from my iPhone using SuperCub.Org

[aktango58]

Put some Non-Skid tape down and be done!!

Depends on what you want to see

[brown bear]

No need for scuff plates .I used Poly fiber epoxy varnish . It wears like iron ! Mine has been on for 2300 hours and still looks great , even were my heels ride .
POLY-FIBER STITS EPOXY VARNISH EV-400 / EV-410

https://www.aircraftspruce.com/catalog/pnpages/09-05645.php?gclid=EAIaIQobChMIiMPC5Jma7gIVyNXACh34qA oIEAQYASABEgJf1fD_BwE

[hotrod180]

Put some Non-Skid tape down and be done!!

Depends on what you want to see

Is non-skid really what you want there?
I would think something smooth so your feet can move back & forth freely.

[NunavutPA-12]

Self-stick floor tiles work well. Cut to size.

[Steve Pierce]

The original Piper heel plates have a cut out and broken edge to orient them correctly in relation to the hole in the floor for the brake pedal. I have found no source for the originals. Since others don't use them maybe someone has an original set stashed somewhere you can have.