chadden
MEMBER
Ireland
I am servicing an Edo-Aire gascolator/fuel strainer on a PA18
There is a top and bottom rubber washer seal for the outer can. The internal strainer mesh should be held in place with locking wire (but was not). However even when properly wired there is still clearance between the strainer cup and the top of the unit which suggests that there should be an internal washer seal on this too.
Edo-Aire is no more and I cannot find much information other than e-bay images online. Has anyone encountered one of these units. Directions to where I might source a washer kit would be most useful. (I could try making a set of course)
There is a top and bottom rubber washer seal for the outer can. The internal strainer mesh should be held in place with locking wire (but was not). However even when properly wired there is still clearance between the strainer cup and the top of the unit which suggests that there should be an internal washer seal on this too.
Edo-Aire is no more and I cannot find much information other than e-bay images online. Has anyone encountered one of these units. Directions to where I might source a washer kit would be most useful. (I could try making a set of course)
Attachments
Last edited: