Grant
FRIEND
At Work.....
We have a taper shaft 65HP that is coming off and we have an overhauled flanged shaft 65 Going on. We are using the same prop model but a finer pitch. Will the bolts be the same between the taper and flange shaft? I assume we use the front crush plate and just bolt it up to the flange without the bushings and that should be it.... i just want to know before we are sitting there wishing we would have had this solved before the prop shows up in a week.
I could not find any direct refrence when searching and the Sensinich guys are gone for the day.....
Thanks!
I could not find any direct refrence when searching and the Sensinich guys are gone for the day.....
Thanks!