Guys: I’m starting to order some stuff for the Cub project. I’m a bit confused about drag wire size. I was thinking 1/8” as a 6-40 nipple is supposed to thread on the ends yet the holes in the strut are drilled for 3/16” where the #4 compression strut is located. Plans say to place drag wire inside the compression tube. Now I’m confused.....are we talking 1/8” or 3/16” or are we saying 1/8” goes in the four bays and 3/16” goes inside the compression tube?
Thanks for any guidance,
Sarpy Sam
Thanks for any guidance,
Sarpy Sam