Hi
I am replacing the Eisemann Magnetos on my A65 with Slick 4333. I cannot find any information on the torque value for the drive gear retaining nut. Also should the gear have a bit of end play. The nut has to be slacked off a bit to align with the pin hole in the shaft. Otherwise the nut has to be tightened hard to match the next hole. Do I have to use shims? Any advise would be appreciated.
Thanks
Roger
I am replacing the Eisemann Magnetos on my A65 with Slick 4333. I cannot find any information on the torque value for the drive gear retaining nut. Also should the gear have a bit of end play. The nut has to be slacked off a bit to align with the pin hole in the shaft. Otherwise the nut has to be tightened hard to match the next hole. Do I have to use shims? Any advise would be appreciated.
Thanks
Roger