As scary as it may sound, but...perhaps my little pea brain was hearing your thoughts...First thing this morning I measured, marked and was getting ready to cut skin and it became apparent that I didn't have very much left in the piece after I cut out the access holes. I soon realized this was a bad idea so I made a command decision and grabbed a broom and swept up a bit of the shop. When I got done I looked at the layout of holes in the skin and it was clear that this was wrong so I'm going with one piece of 0.032 with no holes.
Thanks for the thoughts wherever they came from...and people think it's wrong to listen to the voices.
I have a light weight bar and that's just as bad...#2 son is coming over this afternoon so he can buck these rivets.
Thanks for the thoughts wherever they came from...and people think it's wrong to listen to the voices.
I have a light weight bar and that's just as bad...#2 son is coming over this afternoon so he can buck these rivets.