Search:

Type: Posts; User: stewartb

Page 1 of 20 1 2 3 4

Search: Search took 0.10 seconds.

  1. Traffic “In” isn’t required in any airspace. It...

    Traffic “In” isn’t required in any airspace. It may be part of an STC instrument install but I know nothing about that.
  2. Replace the yoke.

    Replace the yoke.
  3. Replies
    23
    Views
    1,713

    With extended wings and extended airframes we...

    With extended wings and extended airframes we have lots of variables within the slat-Pstol fleet. I can pull 1 notch of flaps at 50 but usually am closer to 40. I have no lateral drift in still air...
  4. Replies
    12
    Views
    1,253

    Why not take your choice of cutting tool and...

    Why not take your choice of cutting tool and radius the strut fitting to address interference? It looks pretty minor.
  5. Replies
    10
    Views
    790

    He looks like a Romeo to me. Good looking boy! ...

    He looks like a Romeo to me. Good looking boy!

    I use a mountain theme. The last dog was McKinley. This one is Spurr.

    Welcome back. You’ve been away awhile! :)
  6. Replies
    10
    Views
    887

    Carefully bend the ears to open them up a teensy...

    Carefully bend the ears to open them up a teensy bit. Mine were too Effing tight, too.
  7. Replies
    10
    Views
    608

    I touch up using the same Imron or Aerothane used...

    I touch up using the same Imron or Aerothane used for the plane. Just make sure you use fresh catalyst. The paint never goes bad. I use paint dabbers from the auto finish store or Amazon. The dabbers...
  8. Replies
    18
    Views
    883

    Other way around. Into the perimeter and returns...

    Other way around. Into the perimeter and returns through the center. Without the backflow preventer all the filtered particles could return to the engine. When I remove a filter and make the...
  9. Replies
    18
    Views
    883

    When disassembling engines I don’t recall much...

    When disassembling engines I don’t recall much oil other than what was clinging to surfaces. My primary interest is whether it’ll purge my oil coolers. Probably not a big deal either way but I’m...
  10. Replies
    18
    Views
    883

    All pressurizing will do is push the oil though...

    All pressurizing will do is push the oil though the filter to empty it. There’s an anti-backflow valve that keeps the oil on the dirty side from draining down. No different than gravity when you...
  11. Replies
    18
    Views
    883

    You’ve never driven a punch into a filter can?

    You’ve never driven a punch into a filter can?
  12. Replies
    18
    Views
    883

    new interesting oil change tool

    If it purges my coolers Iíll be pleased. I like other items Iíve bought from ASA so I ordered one to try.

    https://antisplataero.com/products/asa-ez-oil-filter-drain
  13. Replies
    0
    Views
    289

    Stranded wire to terminal blocks

    Skup sent me a YouTube link about wire ferrules. I didnít know these existed until I watched it but I knew instantly it would solve the poor wire retention problem at my Pmags. I bought a similar kit...
  14. Replies
    105
    Views
    19,505

    Petrified contact cement. Everyone who strips it...

    Petrified contact cement. Everyone who strips it is confounded by it. Try enamel reducer. It worked better than anything else I tried. It was the best balance between solvent power and not...
  15. Replies
    22
    Views
    2,456

    The jack I posted about is particularly handy for...

    The jack I posted about is particularly handy for swapping tires to skis and vice-versa since there's space between the jack and wheel or ski. There isn't enough room to remove Fluidynes on my 180...
  16. Replies
    23
    Views
    1,713

    I’ve heard Wayne Mackey has tried his slats...

    I’ve heard Wayne Mackey has tried his slats lowered one inch and went back to 1/2”, but that’s second hand info. One long time slat pilot I know has tried flush and 5/8” down and he thinks 5/8” is...
  17. Replies
    23
    Views
    1,713

    Re: slat gust locks. Post #296 on page 8 of the...

    Re: slat gust locks. Post #296 on page 8 of the Wildcat Cub thread shows them. Mike added a longer stop screw so I can attach a UHMW disc with a wing nut to block the slat in the closed position....
  18. Replies
    23
    Views
    1,713

    The only way the slat brackets would abrade the...

    The only way the slat brackets would abrade the leading edges would be if there was motion. If you have movement there you need to eliminate it. Teflon tape is unnecessary and is probably a bad idea....
  19. Replies
    23
    Views
    1,713

    I used nut plates for my slat hangers. I thought...

    I used nut plates for my slat hangers. I thought it would be better than PK screws into the leading edge metal. Of all the slat guys I know or have talked to Iím the only one with nut plates. I...
  20. Replies
    22
    Views
    2,456

    Another Pirep. I picked up the Cessna gear leg...

    Another Pirep. I picked up the Cessna gear leg fixture that fits the same jack. I think the Cub jack is the best jack Iíve tried but this Cessna fixture is way, way better than anything Iíve used to...
  21. Replies
    29
    Views
    1,677

    OMG. It’s time for me to join Mike!

    OMG. It’s time for me to join Mike!
  22. Replies
    43
    Views
    3,119

    A simple ‘yes” would have sufficed.

    A simple ‘yes” would have sufficed.
  23. Replies
    29
    Views
    1,677

    I was careful. It’s good rye.

    I was careful. It’s good rye.
  24. Replies
    29
    Views
    1,677

    2nd dose of Pfizer

    Got shot #2 today. The pharmacist said thereís a chance I may feel flu-like symptoms tomorrow. I bought a bottle of Rye. I donít like leaving anything to chance. ;)
  25. Replies
    19
    Views
    1,261

    I think this situation is a shame. My G3X Touch...

    I think this situation is a shame. My G3X Touch is a joy to fly with.

    Re: power conditioning? Garmin recommends it. I have nonidea what the other mfgrs say. I have surge protectors and battery...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4