Search:

Type: Posts; User: tkj

Search: Search took 0.01 seconds.

  1. Thread: pulleys

    by tkj
    Replies
    0
    Views
    969

    pulleys

    Are phenolic pulleys lighter than aluminum pulleys? Less expensive? What do you refinish them with?I have noticed most kits use aluminum .
  2. Replies
    7
    Views
    2,083

    fuel tank stap felt

    Is there a better material to line the fuel tank straps with and where do you get it
  3. Thread: screws

    by tkj
    Replies
    1
    Views
    1,218

    screws

    Where can I get the "PK" screws used to attach the ribs to the spar? Is it alright to use stainless steel screws in aluminum/
  4. Thread: Schneider cub gear

    by tkj
    Replies
    50
    Views
    17,110

    Anyone have contact info for rick? I'm building a...

    Anyone have contact info for rick? I'm building a 160 cub down here in georgia,would trade a little rough field for a bit more speed.
  5. Thread: 0-320 engine

    by tkj
    Replies
    7
    Views
    3,446

    I'll be building it light , duplicating some of...

    I'll be building it light , duplicating some of the carbon cub parts.
  6. Thread: 0-320 engine

    by tkj
    Replies
    7
    Views
    3,446

    0-320 engine

    I'm building a 32" wing span supercub with 1320 gross. what is the best model of 0-320 , a1a,a2d,etc ? has to be conical mount.
  7. Thread: pulled rivets

    by tkj
    Replies
    14
    Views
    6,761

    I'm using ad 4-4 rivets on .060 riveted to .016 ...

    I'm using ad 4-4 rivets on .060 riveted to .016 a little over 3/16 inch from edge. All is 2024t3. I' working with only 9/16 inch width and I can't get any closer to the cap strip or my squeezer...
  8. Thread: pulled rivets

    by tkj
    Replies
    14
    Views
    6,761

    I'm using ad 4-4 rivets on .060 riveted to .016 ...

    I'm using ad 4-4 rivets on .060 riveted to .016 alittle over 3/16 inch from edge. All is 2024t3. I' working with only 9/16 inch width and I can't get any closer to the cap strip or my squeezer...
  9. Thread: pulled rivets

    by tkj
    Replies
    14
    Views
    6,761

    By soft I mean a as opposed tgo ad rivets. I...

    By soft I mean a as opposed tgo ad rivets. I would rather use 1/8 cherry max q but I'm not sure that's thed right pulled rivet.
  10. Thread: pulled rivets

    by tkj
    Replies
    14
    Views
    6,761

    pulled rivets

    I'm building sc ribs from extruded t-section,what type pulled rivits should I use? When I use solit rivets they seem to deform the extrusion to each side of the rivet.
  11. Replies
    1
    Views
    2,030

    exp supercub/pacer wings

    A friend and I are building 2 experimental supercubs with 0-320,s , and the wings will be scratch build copyies of pa-22 wings ,each wing squared off with sullivan tips for about a 31 ft wing span....
Results 1 to 11 of 17