Search:

Type: Posts; User: TurboBeaver

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    25
    Views
    729

    Steve this 180lb STC for baggage you are refering...

    Steve this 180lb STC for baggage you are refering to, is that the same one we used to call the "third seat" STC. That X brace looks firmilar.


    Sent from my LM-X210 using SuperCub.Org mobile app
  2. I think Stew is correct, Charlie may have the...

    I think Stew is correct, Charlie may have the only current STC available for an E series engine......
    I remember some of these old STC like " seaplane door" for Champs,
    When old guy died in...
  3. One of the most common ones used is the Kenmore...

    One of the most common ones used is the Kenmore Air STC.
    Simple mod basically just requires 18 tailfeathers and sleaving the lower engine mount tubes. Call Kenmore they should be able to hook ya up....
  4. Replies
    14
    Views
    3,453

    Phil, For lots of reasons; simply make the...

    Phil,
    For lots of reasons; simply make the switch to the 0320.
    No matter which 0235 series engine you run there is simply NO comparision in performance. No matter how you try to justify it ;...
  5. Replies
    65
    Views
    2,645

    You may be looking at the wrong end of your Cub...

    You may be looking at the wrong end of your Cub for your culprit......
    There is often a direct link to the tailwheel in ground loop accidents.
    If it is not working correctly ( huge percentage of...
  6. Welcome. A guy in FL had a gig to overbore the...

    Welcome. A guy in FL had a gig to overbore the clyinder base holes out to accept 0320 clys. " Outlaw Engines"
    Used to be $100 a hole from memory.
    Probably lots of shops giged up by now. Again good...
  7. Replies
    9
    Views
    1,889

    Adding 2 extra pounds of weight is a bit of a...

    Adding 2 extra pounds of weight is a bit of a mystery when converting from a long mount to a short mount????
    The shorter mount will move the CG aft to start with. So I wonder why the mechanic...
  8. Robert, One of the reasons the 0290's blow so....

    Robert,
    One of the reasons the 0290's blow so. much oil from the breather tube is
    the case design compared to the 0320's. The forward mounted exit position on the 0290 breather tube was a very poor...
  9. Replies
    33
    Views
    1,586

    Nice to see the old Skyranger on here! It was...

    Nice to see the old Skyranger on here!
    It was almost my first airplane, there one here at Pushaw Lake in the mid 70's. Yellow and Blue ceconite recent cover, mid time C85 that ran great. On Federal...
  10. Replies
    1
    Views
    334

    I think those were sold in the 60/70s as the "...

    I think those were sold in the 60/70s as the " Northwind Ski" by Wag Aero.
    I had a pair on a 90hp Champ, with extended Teflon bottoms they were excellent on that 850lb airplane.

    Sent from my...
  11. With wood spars that attach same as a J3, its...

    With wood spars that attach same as a J3, its interesting they refered to this as a Super Cub? This looks totally
    a wood wing Wag Aero " Sport Trainer" (J3) with an 0320 on the front ? It has got...
  12. Interesting side note: I have a buddy that has...

    Interesting side note: I have a buddy that has two old PA 12 fuselarge's. Both of them have that diagonal tube
    bent from rough landings in "exactly" that position the original factory seaplane brace...
  13. The original mod from Edo requires two tubes that...

    The original mod from Edo requires two tubes that simply bolt in. No welding involved......... If you are pre cover with bare fuselarge then go ahead and weld in the vertical tube.
    If not just add...
  14. Replies
    64
    Views
    4,697

    Dont forget a very important factor to holding a...

    Dont forget a very important factor to holding a Cub in winds in excess of 50kts is the flimpse piece of channel that conects your spar to your strut is the fuse........ Hundreds have failed over the...
  15. Replies
    2
    Views
    651

    Alot of folks dont know about them but Lycoming...

    Alot of folks dont know about them but Lycoming made lots of factory narrow deck 160hp engines. I bought a rebuilt 12 back in the 80's that had been redone by an A&P School in Idaho that used to do...
  16. Replies
    17
    Views
    2,333

    The Pstol flaps will draw some attention, from a...

    The Pstol flaps will draw some attention, from a limited audience;
    A set of 350CC " Lady Bumps" will
    draw major attention worldwide to a massive part of the population ( both genders!) and likely...
  17. Replies
    20
    Views
    1,412

    Ron, This is what they look like........ Mt...

    Ron,
    This is what they look like........
    Mt Cook boys used to know all about them??? When I lived in Wanaka they had two C 206 in Te Arnu on 3430s.44120

    Sent from my LM-X210 using SuperCub.Org...
  18. Darn nice looking 12! Bet it's a great performer?...

    Darn nice looking 12! Bet it's a great performer? Extended baggage ???


    Sent from my LM-X210 using SuperCub.Org mobile app
  19. If your right handed you should be able on the...

    If your right handed you should be able on the left side; to jump right up onto a 31" tire and go right up over the leading edge with a 6 gal Jerryjug if you get the swing right. The right side is a...
  20. Replies
    9
    Views
    1,235

    Back when the aluminum Gruman Canoes were...

    Back when the aluminum Gruman Canoes were popular, they had 15' and the 17' ers. The latter was called
    the "Princess". All the flying services
    around here hauled them everyday. Hauling two 17fters...
  21. Replies
    1,341
    Views
    333,374

    Pete, After reading this post a few times, and...

    Pete,
    After reading this post a few times, and trying to see Georges point of view. This whole thing doesnt add up[emoji15] Something is wrong here......nobody puts a 5hr float time pilot in the...
  22. Replies
    31
    Views
    7,539

    Has been an age old problem since the early under...

    Has been an age old problem since the early under wing sight gauges.....[emoji15] My old 12 guages will show only 3/4 per side after 30 mins of flight filled right to covers.... When the ball is...
  23. Replies
    24
    Views
    2,011

    Cant believe how high your grass is down there!...

    Cant believe how high your grass is down there! WoW we have not mowed
    our lawn yet here! Looks like mid July would........[emoji15]

    Sent from my LM-X210 using SuperCub.Org mobile app
  24. Replies
    1,341
    Views
    333,374

    Just what I was thinking Pete, I cant imagine you...

    Just what I was thinking Pete, I cant imagine you could get him insured? We used to think most lodge pilots had to have 500 hours on floats with 100hrs in TYPE to get any kind of a decent rate ? I...
  25. Replies
    11
    Views
    936

    In the factory configuration and unmolested; most...

    In the factory configuration and unmolested; most 12s would have
    a vertical oriented " header tank" down
    by the left rudder pedal. The two original valves should be placarded
    MAIN on left tank;...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4