Search:

Yes. They have a website and an eBay store

Plus one for Macs…cheap price…great cover… very well made.
64433I’m
64434

I looked high and low for 1500A Baumanns…I have a set of straight but wanted my experimental 11 to be on amphibs for the reason Douten cites. I settled for a set of Mead which are nice…same weight...

I’ll tell you my side by side experience: I owners 2 Taylorcraft BC12D …one with an 85…the other with a 90…I thought it was similar to the difference between my 65 hp and 85 hp Tcraft’s when I bought...

I’m doing a fabric job (recovering a J3) and I decided to put up temporary walls to make a smaller area to heat. I put plastic on both the inside and outside of the walls. I heat with a ceiling...

I have a 125,000 BTU Mr Heater Big Maxx ceiling mounted propane heater…they are about $750-$800 and work very well. It’s a direct vent type unit. My hangar is also 50x50

My 11Ex with O200 does ok on trick airs…there is a lot more drag for sure. Planning and knowing what your setup is capable of is key of course. I do like the utility of landing on the runway and...

Looking good! I have to say, I really had fun rigging my floats. I learned so much from all of you here on this site. Oli, do leading edge slats change your AOA significantly on landing? I’m...

63922

Wire pulls are the method I used…very solid install.
63854
I agree with Pete about the eye bolt…not the best application maybe. I guess any of the options you illustrated as far as the location to...

It’s so much easier and quicker than the seine knot that I’ll never go back.

63839

I use that stagger wing knot…much easier!!

Thanks…I knew there was some good reason. I just couldn’t remember what it was.

I have a friend asking why not use Wag Aero sealed struts on J3?

Michigan required taxes after registration….So, that is an issue depending on where you live.

I registered mine almost a year before it was complete

https://www.aopa.org/news-and-media/all-news/2020/january/23/why-insurance-rates-are-increasing-10-to-100-percent
This article from a couple years ago was interesting. It makes me think that the NX...

I bought some Harbor Freight screw jack type tall stands and used them to stabilize my plane when I had it hanging from a chain hoist while I built my float rigging. I had placed a 2x4 across the...

I have an experimental 11 but I have a folding, adjustable front seat that I leave in the full back position making it quite comfy. Mounts in the standard location. It slides back 2 1/2” homemade of...

One nice thing about the Wag Aero plans for a PA11/J3 replica is the allowable 1400lb gross weight listed on the plans. Unless you want or need to go light sport, then you set your gross at 1320 when...

So this will be the same prop for C90, O200, O235?

Oil pressure is within limits for the C90. 30-40psi per the type certificate. Are you just worried about fluctuations?

You need hydraulic fluid. Most snowplow fluids meet the spec. Mil spec - 5606

The Douten takeoff is just after 4:40.00 into this video I already found on You Tube….Jim Crane Vs Dan Dufault is the one before it….and just keep watching to see them go again. Great Job guys…what a...