Search:

Type: Posts; User: motosix

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    214
    Views
    13,903

    How in the hell did this thread turn into a NORDO...

    How in the hell did this thread turn into a NORDO conversation?
  2. Replies
    214
    Views
    13,903

    You are missing the point: A device which is...

    You are missing the point:

    A device which is arguably more useful in 99.999% of our flying situations is not required by regulation. (our beloved radio)

    A device which can be nice to have yet...
  3. Replies
    214
    Views
    13,903

    Flying with your radio turned off is not...

    Flying with your radio turned off is not punishable with the loss of your license.
  4. Replies
    214
    Views
    13,903

    Is it bad that I believe this is exactly what...

    Is it bad that I believe this is exactly what their intent was?

    This set of rules was written almost entirely on behalf of big iron flying in the sky. Bug smashers like us should not get any say...
  5. Replies
    214
    Views
    13,903

    That is not how I intended it, but I like the...

    That is not how I intended it, but I like the creativity...

    It is way easier just to have a loose connection from the GPS source to the transponder...No GPS, no ADSB. Transponder is still fully...
  6. Replies
    214
    Views
    13,903

    This is absolute truth, however I could use one...

    This is absolute truth, however I could use one of these:

    https://www.amazon.com/Mission-Darkness-Non-Window-Faraday-Phones/dp/B01A7MACL2

    ...and not lose my ticket over it.
  7. Replies
    214
    Views
    13,903

    ADSB is a small data payload and a CRC check on...

    ADSB is a small data payload and a CRC check on the end. That's it. (https://mode-s.org/decode/adsb/introduction.html)

    There is no signature that can be verified (I can say I am anyone in the sky...
  8. Replies
    83
    Views
    4,993

    Just curious: Could you elaborate on your...

    Just curious:

    Could you elaborate on your deflection vane for #4? Deflecting air from the side of the cowl, or the top down to #4?

    Also, how did you end up find the binding rocker arm?
  9. Replies
    20
    Views
    1,292

    Thanks, I appreciate the details. I have a...

    Thanks, I appreciate the details.

    I have a small bending brake, but not one wide enough to do these parts...
  10. Replies
    20
    Views
    1,292

    Those must be really narrow fingers on that brake...

    Those must be really narrow fingers on that brake to be able to do those bends??

    You make everything look easy with the fab on your airplane, so I shouldn't be surprised you didn't have any...
  11. Replies
    20
    Views
    1,292

    I was considering taking some .020" 4130 tube,...

    I was considering taking some .020" 4130 tube, cutting a shallow V down the seam to allow me to make a very slight cone, then welding the seam and ends to the different sized main tubes. Besides...
  12. Replies
    20
    Views
    1,292

    Thanks for the video links. I never considered...

    Thanks for the video links. I never considered attempting a rubber hydro-ish-form for this, but will go watch and learn!
  13. Replies
    20
    Views
    1,292

    I was considering that for the horizontal stab...

    I was considering that for the horizontal stab ala Zenith and lesser so Bearhawk.

    Building them straight seemed to be a bit of a challenge without tool dies for the brake, so I was going to start...
  14. Replies
    20
    Views
    1,292

    Fabing Piper(ish) Rudder / Elevator Ribs

    I remember (?) seeing some posts of the process of fab'ing the ribs for the elevator/rudder but can't seem to find them. (Olibuilt? Was that you?)

    If not already obvious, I am curious from the...
  15. Replies
    3
    Views
    788

    WTB: Indeed I am. PM with details! Thanks.

    Indeed I am. PM with details!

    Thanks.
  16. Replies
    18
    Views
    1,250

    When I had a starter, I could damn near taxi on...

    When I had a starter, I could damn near taxi on the EarthX alone. If I pulled the spark plugs, I might even have been able to get up into ground effect before smoking the starter. These batteries are...
  17. Replies
    18
    Views
    1,250

    That was the crux of my initial question: I was...

    That was the crux of my initial question: I was curious what the 9volt battery (or backup battery) circuit looks like for pmag initial power. It sounds like an example of that circuit may be found in...
  18. Replies
    18
    Views
    1,250

    These require a flywheel to allow crank position...

    These require a flywheel to allow crank position triggering via magnets.
  19. Replies
    18
    Views
    1,250

    For those of us with (small) alternators,...

    For those of us with (small) alternators, batteries, no starters, but with dual slick/bendix mags, my wiring is pretty straight forward.

    Anyone have any diagrams showing how one might power a...
  20. Replies
    14
    Views
    981

    I was guessing that was going to be your answer,...

    I was guessing that was going to be your answer, but thank you for the explanation.

    I bundled my p-leads together and passed them through their own breech in the firewall keeping them away from...
  21. Replies
    14
    Views
    981

    Although prudent, could you expand on this...

    Although prudent, could you expand on this statement just for my own education? (the wires are shielded, a wire failure would fail a mag open, etc..)
  22. Replies
    2
    Views
    400

    I have nothing to add to this thread but a free...

    I have nothing to add to this thread but a free bump...

    However it is comical that my name is Dave and I fly a PA11 (albeit, experimental) and you fly a really beautiful Husky, yet your screen...
  23. Replies
    3
    Views
    788

    WTB: ^

    ^
  24. Replies
    14
    Views
    1,240

    This captured my interest and am just curious: ...

    This captured my interest and am just curious: Are -18 wing tanks vented across the birdcage to each other?
  25. I followed that build and install and really...

    I followed that build and install and really enjoyed the solution.
Results 1 to 25 of 80
Page 1 of 4 1 2 3 4