Search:

Type: Posts; User: Pacerfgoe

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    32
    Views
    1,280

    Have you changed the oil filter? Maybe something...

    Have you changed the oil filter? Maybe something internally going on there.
  2. Replies
    19
    Views
    3,590

    The hose out the window is the way to go....good...

    The hose out the window is the way to go....good suction is provided and not messy at all, you’ll get a good spread but not sure how wide it will be....
  3. Replies
    155
    Views
    26,731

    Now you'll have to close up that bottom cowl like...

    Now you'll have to close up that bottom cowl like it used to be and see if things remain constant.....
  4. Replies
    47
    Views
    6,238

    The approved data for changing 150 hp to 160 hp...

    The approved data for changing 150 hp to 160 hp is the type Certificate data sheet. Over 60 different models of the same engine with subtle changes. Use th3 parts book and bolt on the correct...
  5. Replies
    11
    Views
    2,100

    Picture of what’s required....

    Picture of what’s required....
  6. Replies
    110
    Views
    17,642

    Is that lower gear loose and moving around when...

    Is that lower gear loose and moving around when you slide it into position without the other gear installed?
    By any chance was it installed dry on inital installation? If so that's probably wear...
  7. Replies
    110
    Views
    17,642

    In the last picture you posted it looks like the...

    In the last picture you posted it looks like the oil is coming out the pump from a hole.....is that true?
    if so this is likely your problem. You shouldn't have substantial leaks like that out of...
  8. Replies
    75
    Views
    12,542

    :yikez:

    :yikez:
  9. Replies
    4
    Views
    1,501

    Like to see that happen in 10' seas.....

    Like to see that happen in 10' seas.....
  10. Thread: Engine woes

    by Pacerfgoe
    Replies
    64
    Views
    7,635

    Are you getting good mag checks on runup? maybe...

    Are you getting good mag checks on runup? maybe you have a plug or two that isn't up to the task at high power settings and are misfiring.
    It's been mentioned before, but how fresh is the fuel.....
  11. Replies
    10
    Views
    1,724

    I looked at the tracker, he was at it early this...

    I looked at the tracker, he was at it early this morning....
  12. Replies
    39
    Views
    9,179

    Hey Mike....did you get the belts I sent?

    Hey Mike....did you get the belts I sent?
  13. Replies
    14
    Views
    2,078

    ATC probably just being cautious with the...

    ATC probably just being cautious with the airliner, and if the military needed to launch on an intercept, they will....my 2cents....or 1 1/2 cause I'm Canadian!
  14. Replies
    5
    Views
    3,807

    There are lots of parts carbs around, I'd see if...

    There are lots of parts carbs around, I'd see if I could find one that fits your application and just use the top part.
  15. Replies
    39
    Views
    9,179

    Put them in the mail today, should be there in...

    Put them in the mail today, should be there in about 10 days....
  16. Replies
    39
    Views
    9,179

    Just changed out the belts in my Pacer.....Dated...

    Just changed out the belts in my Pacer.....Dated 1969 and 1970 in the front, and 1956 in the back.

    Mike, you still up for donor belts? if so, I'll send them to you.... PM your address.
  17. Double post

    Double post
  18. Get at least half of those 500 Hrs at nighttime...

    Get at least half of those 500 Hrs at nighttime as PIC.....you can thank me in 5 yrs.
  19. I've seen this once before, but it's nice to see...

    I've seen this once before, but it's nice to see it again. That generation gave up an awful lot, so we can do whatever we like today.....Thank you!!
  20. Replies
    180
    Views
    25,534

    Just so you know, those spot faced cylinders you...

    Just so you know, those spot faced cylinders you have are not compatible with the cylinder base plates to go to 160 hp....you'd need new narrow deck cylinders without the spot face, longer studs, and...
  21. Replies
    135
    Views
    12,809

    Do you have the baffle underneath the engine that...

    Do you have the baffle underneath the engine that directs the airflow entering the rectangular opening in the cowl, underneath the crankcase and spills the cool air onto the oil tank?
  22. Replies
    83
    Views
    8,025

    Looks like the weather is warming this week and...

    Looks like the weather is warming this week and the weekend looks not too bad....hope your able to get away!
  23. Replies
    83
    Views
    8,025

    Pinned on my Ipad....I'm sometimes in the area...

    Pinned on my Ipad....I'm sometimes in the area too, we always monitor 126.70 and 121.50. A handheld can be your friend out there too.
    I hope you get some nice weather. Watch out for the flat...
  24. Replies
    135
    Views
    12,809

    One item that hasn't been discussed here is a...

    One item that hasn't been discussed here is a rolled bottom firewall lip. I have no experience with this, but have read that it can really improve airflow out the cowl, by converting turbulent flow...
  25. Replies
    48
    Views
    4,678

    That first pic is just painful....

    That first pic is just painful....
Results 1 to 25 of 114
Page 1 of 5 1 2 3 4