Search:

Type: Posts; User: coxcub

Page 1 of 10 1 2 3 4

Search: Search took 0.01 seconds.

  1. It's fine in my part of uk - Windows 10 and...

    It's fine in my part of uk - Windows 10 and Firefox - no noticeable difference from before.

    Frank
  2. SkySports capacitance fuel sender calibration

    Folks

    I have an oldish (2010) 'SkySports' capacitance fuel sender in my 'Other plane' which requires a magnet to calibrate it. I have mislaid the procedure instructions...
  3. This could be handy for the reference library -...

    This could be handy for the reference library - parts list towards the back of it -

    http://republicseabee.com/Files/Marvel-Schebler%20Service%20Manual.pdf

    Frank
  4. Replies
    24
    Views
    1,635

    Web, It is a requirement over here to have a...

    Web,
    It is a requirement over here to have a compass with an in date deviation card so I am stuck with sorting it out.
    Frank
  5. Replies
    24
    Views
    1,635

    Folks, This is a topic very close to my heart at...

    Folks,
    This is a topic very close to my heart at present. I am getting close to finishing a Fairchild UC61K and am now clearing up the smaller items. However the mag compass is 'Stuck on 100*' what...
  6. Replies
    11
    Views
    1,320

    Bingo! - thank you Steve. Frank

    Bingo! - thank you Steve.
    Frank
  7. Replies
    11
    Views
    1,320

    That's strange - I click on 'forum' and get a...

    That's strange - I click on 'forum' and get a completely different format with 'V Bulletin' at the top
    Perhaps it's my browser which updated yesterday - I'll work on it.
  8. Replies
    11
    Views
    1,320

    New website format

    Whilst I am not fully up to speed with this new format is it possible to still get 'New since last visit'? - that was really handy.
  9. Philly I pulled this up from the LAA TL3.26...

    Philly

    I pulled this up from the LAA TL3.26 (Technical leaflet)

    "A low voltage warning light is still mandated on certain UK aircraft with Certificates of Airworthiness by means...
  10. Replies
    26
    Views
    3,559

    David A home built Eurofox has just completed a...

    David
    A home built Eurofox has just completed a UK to NZ trip with apparently no real problems.
    His crossing of the Tasman sea was via Lord Howe Island - not sure if you were aware of it....
  11. Replies
    26
    Views
    8,737

    Cut/have cut a hard stencil for the curvy bits...

    Cut/have cut a hard stencil for the curvy bits and the registration, mark out with a pencil using a straight edge for the straight bits and - mask with 'fine line' tape, narrow for the curvy bits -...
  12. Replies
    34
    Views
    3,044

    Don't turn the can upside down to clear the...

    Don't turn the can upside down to clear the nozzle - it wastes propellant - just take the plastic nozzle fitting off, soak it for a few minutes in thinner/gun wash, blow through with an air gun and...
  13. Big crane for this one! 39409

    Big crane for this one!

    39409
  14. Replies
    14
    Views
    2,866

    Speak with Chris or Alex - the UK agents for Poly...

    Speak with Chris or Alex - the UK agents for Poly Fiber - they are always ready to help and answer questions. I'm pretty sure they can match colours. AIRCRAFT COVERINGS LTD Henstridge Airfield,...
  15. Thank you Philly for that - My old one is...

    Thank you Philly for that -
    My old one is working very well but I am just covering my backside for the future!
    My SC is grounded at the moment for want of a Bungee tool. However help is at hand...
  16. Replies
    108
    Views
    18,035

    Thanks Hardtailjohn - My interest in using this...

    Thanks Hardtailjohn - My interest in using this is increasing but nearest distributor is in Holland.
    Also need to check on 1956 colours being available.
    Frank
  17. Replies
    108
    Views
    18,035

    Thanks 'Hardtailjohn' and 'Algonquin' for the...

    Thanks 'Hardtailjohn' and 'Algonquin' for the info - it seems that high humidity is not really a factor other than prolonging the drying time due to slow evaporation of the water carrier. However is...
  18. Philly - which solid state regulator did you go...

    Philly - which solid state regulator did you go for? - I may well be in the same boat down the road.
    Thanks
    Frank
  19. Replies
    108
    Views
    18,035

    Slightly off Topic but how sensitive is Stewarts...

    Slightly off Topic but how sensitive is Stewarts to Temperature/humidity? I live in the land of the '40 knot fog' where 2/3s of the year is very damp. Poly Fiber went on perfectly in temps of 65ish...
  20. Yes, I have - as an amateur I had no problems at...

    Yes, I have - as an amateur I had no problems at all - really easy to get a good finish.

    Frank
  21. I use non stick oven liner instead of parchment...

    I use non stick oven liner instead of parchment paper - never a problem with it lifting the poly tone off and the iron slides over it really well.

    Frank
  22. http://img.photobucket.com/albums/v634/Mark12/Albu...

  23. Replies
    51
    Views
    4,023

    Skywagon beat me to it while I was writing my...

    Skywagon beat me to it while I was writing my post!!
  24. Replies
    51
    Views
    4,023

    No - The empty arm (distance of the CofG from the...

    No - The empty arm (distance of the CofG from the datum) is unique to every individual aircraft dependent on how the weight is distributed fore and aft - ie. if the tailwheel is heavy the the arm is...
  25. Replies
    51
    Views
    4,023

    David Are you in the shop for work that is...

    David

    Are you in the shop for work that is going to effect the basic weight? - If so they should weigh it or amend the W&B schedule which will reflect the CofG position and the moment.

    The 'W&B...
Results 1 to 25 of 226
Page 1 of 10 1 2 3 4