Search:

Type: Posts; User: skywagon8a

Page 1 of 20 1 2 3 4

Search: Search took 0.16 seconds.

  1. Replies
    181
    Views
    19,120

    denali, I though that you only wanted one for...

    denali, I though that you only wanted one for yourself and didn't realize that you were wanting to make several of them.
  2. Replies
    1,066
    Views
    293,330

    "The FAA and the National Transportation Safety...

    "The FAA and the National Transportation Safety Board will investigate, Gregor said. He said NTSB is the lead agency, but determining a probably cause for the incident can take a year or more." ...
  3. Replies
    12
    Views
    718

    The few that I've seen are telling me that should...

    The few that I've seen are telling me that should I be wanting a new Cub Legend is the way to go. They seem to be very nice machines.
  4. Thread: Water leak

    by skywagon8a
    Replies
    10
    Views
    625

    This could have been from further back and ran...

    This could have been from further back and ran forward while you were flying? Check to make sure that all of the drain holes are open.
    Does it rain salt water on the Cape which might cause corrosion?
  5. Replies
    69
    Views
    3,081

    Don't forget to insulate it under the tin roof to...

    Don't forget to insulate it under the tin roof to minimize condensation. Do this even if you never plan to heat it.
  6. Replies
    14
    Views
    656

    And power setting dependent.

    And power setting dependent.
  7. Replies
    15
    Views
    915

    What regulation says that old props have to have...

    What regulation says that old props have to have a log book generated for them to remain airworthy? There is a date at which all new props must have log books but what about the thousands of older...
  8. Replies
    20
    Views
    1,168

    This doesn't address replacing a required item...

    This doesn't address replacing a required item with a non 'certified' one.
  9. Thread: Water leak

    by skywagon8a
    Replies
    10
    Views
    625

    Under the wing root fairing into the hole where...

    Under the wing root fairing into the hole where the aileron and flap cables come out??
  10. Replies
    14
    Views
    656

    You must have been using a very flat prop. 2 or 3...

    You must have been using a very flat prop. 2 or 3 more inches of pitch will do wonders without much if any take off penalty. A Cub on 2000s should exceed 100 mph even with an 82" diameter prop.
  11. Replies
    181
    Views
    19,120

    Why don't you just get a piece of dark plexi,...

    Why don't you just get a piece of dark plexi, make a mold to the desired shape and heat it in the oven? When bending in three dimensions as shown in the picture, it is difficult to avoid distortions....
  12. Replies
    56
    Views
    6,296

    Did you look here? ...

    Did you look here? https://www.kestrobes.com/triple-3-light-magnum/ A lot less than $1000.
    Wig-wag landing light control. $50. https://www.kestrobes.com/ltr-landing-taxi-recogniton-light/...
  13. Thread: Icom a200

    by skywagon8a
    Replies
    15
    Views
    686

    It seems to me that if you are spending the best...

    It seems to me that if you are spending the best part of your day in this situation, messing with intercoms is taking way too much time.
    Relocate the intercom control panel to a location where it...
  14. Thread: Water leak

    by skywagon8a
    Replies
    10
    Views
    625

    Radio cooling air scoops? Baggage compartment...

    Radio cooling air scoops?
    Baggage compartment door seal?
    Tail cone compartment pressurization scoops?
  15. Replies
    200
    Views
    25,414

    What is the speed penalty?

    What is the speed penalty?
  16. Replies
    14
    Views
    656

    This type of thing can drive one nuts. Try...

    This type of thing can drive one nuts.
    Try offsetting the water rudders to the left. They act as a trim tab for the rudder.
    Another thing to try is to move the entire float installation to the...
  17. Look at the drawing on page 10....

    Look at the drawing on page 10. https://www.superiorairparts.com/files/1014/0311/7842/SVIOM01.pdf
    The governor mounting pad is well behind the starter ring gear. The starter ring gear is behind the...
  18. Replies
    20
    Views
    1,168

    If that IA will not sign the log book he doesn't...

    If that IA will not sign the log book he doesn't understand the requirements, tell him to call Web to get the straight scoop.
  19. Replies
    22
    Views
    1,336

    Look here for light choices in LED. ...

    Look here for light choices in LED. https://www.superbrightleds.com/ You will be amazed at how much you can get for so little current draw.
  20. Replies
    31
    Views
    737

    no adverse effects. That is one of criterion that...

    no adverse effects. That is one of criterion that the FAA looks at for issuing approvals for modifications.
    Accepting that, What positive effects did you notice?
    I get the elevator and rudder...
  21. Replies
    31
    Views
    737

    I never gave that much thought but yes it should...

    I never gave that much thought but yes it should since it would be operating in undisturbed air.

    Like this....
  22. Replies
    31
    Views
    737

    This one? Page 27 is a list of references....

    This one? Page 27 is a list of references.
    https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19930083935.pdf
    or this one?
    https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19930091708.pdf
  23. Replies
    31
    Views
    737

    Isn't this basically the same thing?

    Isn't this basically the same thing?
  24. Replies
    31
    Views
    737

    Vic, At the high speeds of our airplanes the...

    Vic, At the high speeds of our airplanes the ailerons move very little in order to perform their function. At high speeds there is a slight amount of boundary layer separation and very little...
  25. Replies
    31
    Views
    737

    OK Charlie, let's start with the Aeronca 7 series...

    OK Charlie, let's start with the Aeronca 7 series ailerons since that is the airplane which Gary mentioned.

    Any control surface requires clean airflow over it in order for it to efficiently do...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4