Search:

Type: Posts; User: Steve Pierce

Page 1 of 20 1 2 3 4

Search: Search took 2.81 seconds.

  1. I have only seen the tach cables where the center...

    I have only seen the tach cables where the center cable comes out and have used the new Mitchel's from Spruce. Can you post some pictures? Try John Wolfe Company for your tach repair....
  2. How much slop is in the front liner tube? I would...

    How much slop is in the front liner tube? I would order at least the rear liner tube and if there is any slope in the front it as well. With a couple of people you can push the stabs together as...
  3. Thread: Ebc 102a

    by Steve Pierce
    Replies
    2
    Views
    103

    WTB: I think I have one.

    I think I have one.
  4. Thread: Ebc 102a

    by Steve Pierce
    Replies
    2
    Views
    103

    WTB: Isn't that an ELT?

    Isn't that an ELT?
  5. I have a Northern Companion Engine Pre-Heater,...

    I have a Northern Companion Engine Pre-Heater, never used I would sell. Did not realize they had been discontinued. https://fadodge.com/821-2/
  6. Thanks SJ.

    Thanks SJ.
  7. Replies
    12
    Views
    665

    I on occasion find those pins broken but not on...

    I on occasion find those pins broken but not on tailwheels I have been maintaining. Not sure wat I am doing different but I do not see that very often at all.
  8. Replies
    59
    Views
    6,577

    Not here, still high 90s. Gonna drop down to high...

    Not here, still high 90s. Gonna drop down to high 80s this week.
  9. Replies
    4
    Views
    554

    I have never had an issue with it fitting the...

    I have never had an issue with it fitting the fuselage, just had to flex it to line up. SNOWBALL ;)
  10. They took out a house when they extended runway...

  11. Wheels are 40-84. Not sure on brake calipers....

    Wheels are 40-84. Not sure on brake calipers. Good info on a different brake disc to provide caliper to tire clearance....
  12. My contact in engineering that would look things...

    My contact in engineering that would look things like that up is no longer there. I would call the Cleveland tech number. Had good luck getting answers from them.
  13. Replies
    63
    Views
    3,135

    I would be in pretty bad shape if I lost 50 lbs....

    I would be in pretty bad shape if I lost 50 lbs. ;)

    Weight savings on the airplane is all a compromise. The biggest changes to me is where that weight is removed. Up front sure does make a better...
  14. Replies
    5
    Views
    571

    FS: Sounds like a good deal to me. Isn't a new Borer...

    Sounds like a good deal to me. Isn't a new Borer up to over $5K?
  15. Replies
    8
    Views
    825

    AN363 steel locknut tight but agree with Kevin....

    AN363 steel locknut tight but agree with Kevin. See lots of loose tailwheels.
  16. Replies
    12
    Views
    1,012

    Must be on if installed. Sounds like someone took...

    Must be on if installed. Sounds like someone took that a little further in their head. My Trig TT22 transponder box can be removed with a logbook entry without disturbing the head and the static line...
  17. I look at it as sport. Did you use AC 23-27

    I look at it as sport. Did you use AC 23-27
  18. I can fix you up as well. I am a dealer and have...

    I can fix you up as well. I am a dealer and have been doing the certification flight testing.
  19. I would assume it is the same bolt pattern as the...

    I would assume it is the same bolt pattern as the O-360 but do not know that for a fact.
  20. That is the vendor's document and I have only...

    That is the vendor's document and I have only found it installed in early Carbon Cubs and was hard to figure out which schematic was used to wire it in.
  21. Cub Crafters uses a separate battery for IBBS and...

    Cub Crafters uses a separate battery for IBBS and ignition. Ignition back up is a PowerSonic PS-1221S 2 Ah 12 volt battery that gets replaced annually. The IBBS battery is behind it and is change on...
  22. It will still run on ships battery down to about...

    It will still run on ships battery down to about 6 volts.
  23. Cub Crafters does have a back up battery for the...

    Cub Crafters does have a back up battery for the ignition. Will run it for 1/2 hr plus.
  24. You have to power up the programming lug on the...

    You have to power up the programming lug on the Surely to reboot any timing changes done with the dip switches. Reason I know is I reset the dip switches and thought I was on variable timing but in a...
  25. I have not compared the two. It pulls better than...

    I have not compared the two. It pulls better than a Borer.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4