Search:

Type: Posts; User: Douten

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    37
    Views
    1,741

    My 11 doesn't have extended ailerons and squared...

    My 11 doesn't have extended ailerons and squared / extended wings been flying it for 20+ years so won't be doing this one.
  2. Replies
    11
    Views
    739

    Glenn When has darkness ever deterred you?

    Glenn When has darkness ever deterred you?
  3. Replies
    37
    Views
    1,741

    I'm just basically squaring the wing outside of...

    I'm just basically squaring the wing outside of where the farthest point of rounded tips would be then the fiberglass tips which are about a foot each side. going to place the last rib at 24 inches...
  4. Replies
    37
    Views
    1,741

    I'm squaring the wings and installing fiberglass...

    I'm squaring the wings and installing fiberglass wingtips so two full length ribs outside of the aileron rib (24 inches) I've spliced the spars and ordered full length Dakota ribs and want to be sure...
  5. Replies
    37
    Views
    1,741

    I'm building extended wings for my ex pa-11...

    I'm building extended wings for my ex pa-11 ordered Dakota ribs for the extensions my question is how do most attach the wingtips anchor nuts, clip nuts, tinnerman plates? my other 11 has the...
  6. Replies
    12
    Views
    700

    Are you stroking the engine? that will make a...

    Are you stroking the engine? that will make a huge difference in your performance.
  7. Thread: The big slip

    by Douten
    Replies
    70
    Views
    3,615

    I'm like Crash Jr I slip to most landings. What...

    I'm like Crash Jr I slip to most landings. What will really get your attention when in a really hard slip is to have the window blow into the plane there is a Huge pucker factor for a couple of...
  8. Thread: Got Wood?

    by Douten
    Replies
    35
    Views
    8,682

    I bought a 40 ton from tractor supply 9.5 seconds...

    I bought a 40 ton from tractor supply 9.5 seconds for full stroke also made skis for it so I can even use it at camp.
  9. I had good luck with Curbell Plastics for Kydex...

    I had good luck with Curbell Plastics for Kydex T, I used .040 Black shipped to the door.
  10. Replies
    61
    Views
    3,781

    I run my c-90 PA-11 about 2350 most of the time...

    I run my c-90 PA-11 about 2350 most of the time push to 2400-2450 and I just use oil for a couple of mph.
  11. Peter, Is that similar to Bisexual?

    Peter, Is that similar to Bisexual?
  12. Replies
    6
    Views
    966

    Weld the second tail handle on.

    Weld the second tail handle on.
  13. Replies
    21
    Views
    3,978

    Buddy's c-85 had same symptoms main bearing fit...

    Buddy's c-85 had same symptoms main bearing fit was worn and bearing had slipped.
  14. Replies
    45
    Views
    3,305

    I had a similar problem with my c-90 with a...

    I had a similar problem with my c-90 with a marvel schebler carb suddenly it got worse found the accelerator pump had rust and debris under it and throttle would only open about 1/2 way because of...
  15. Replies
    9
    Views
    818

    Larry, Just come buy my damn 1320's so I can...

    Larry, Just come buy my damn 1320's so I can afford to rebuild the motor for my new 11.
  16. Replies
    13
    Views
    1,324

    a little off subject but I look for a good source...

    a little off subject but I look for a good source of wood first and of course you need some snow also.
    509665096550964
  17. Replies
    8
    Views
    1,319

    I learned a lot from my Dad but I seemed to be a...

    I learned a lot from my Dad but I seemed to be a slow learner about things I thought I could get away with. And boy did he have a big hand!
  18. Replies
    50
    Views
    3,345

    Are the bungees even on both sides of the ears?...

    Are the bungees even on both sides of the ears? Are they locked on one end so they can't stretch? Just thinking.
  19. Replies
    19
    Views
    1,435

    Mechanical drive c-90-8 so tach is counter...

    Mechanical drive c-90-8 so tach is counter rotating haven't had anything apart almost seems like it's disconnected and just vibrating to lower time. I have a new one I just installed in the panel of...
  20. Replies
    19
    Views
    1,435

    I flew the other day in my 11 and when I did my...

    I flew the other day in my 11 and when I did my log something didn't add up I lost over two hours from my last flight thought I must have made a mistake, Yesterday watched the tach rpms were good but...
  21. Replies
    982
    Views
    201,936

    Didn't get to fly today but got some wildlife...

    Didn't get to fly today but got some wildlife pictures with the plane.
    491964919749198
  22. Replies
    34
    Views
    3,402

    Jim, My last Kubota lost the bearings on the...

    Jim, My last Kubota lost the bearings on the front tire spindles 14 times they said it happens about every 500 hours but mine was about 200 that was a 3430 hstc had other major problems they never...
  23. Replies
    77
    Views
    8,427

    Looks like the Ice will be out at camp maybe this...

    Looks like the Ice will be out at camp maybe this week-end or early next week. nice to have things warming up.
  24. Replies
    15
    Views
    1,982

    I wouldn't use USPS unless it was the only option...

    I wouldn't use USPS unless it was the only option left waiting for order shipped 4-23 from Boise ID, 4-24 Twin Falls ID, arrived 4-24 Denver CO, departed 4-28 Denver CO, now in transit to next...
  25. Replies
    16
    Views
    2,141

    Used N-95 mask while sandblasting my fuselage...

    Used N-95 mask while sandblasting my fuselage spent time getting it tight but when looking in the mirror my face had A LOT of dust streaks where they are not effective in stopping everything the air...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4