Search:

Thanks, gents!

I'll see what I can find out about those gentlemen. Once again, thnak you.

All my best,
Rob

Good evening,

Can anyone recommed a trustworthy A&P or IA who knows Short Wing Pipers inside and out to do a pre-buy in the Kansas City area? It would include pulling a cylinder to determine if...

Good afternoon,

Does anyone have any pictures of the Atlee Dodge Safari Seat installed, and installed with cushions? Where did you get your seat cushions, or were they special order?
A search...

Good afternoon, all,

I have a standard PA-18 seat (not with folding STC), and as noted in this forum, the Atlee Dodge seat bottom doesn't fit the standard seat without trimming around the existing...

Correct, but the DER cannot sign the 337 "approving" the field approval. That is clearly defined in Order 8110.37F. You may have ALL the approved data you need, but a DER cannot sign an FAA Form...

DERs cannot do field approvals. They can only approve engineering data within their delegated functions. The data can be used to support a field approval.
DARs with the proper delegation can, ASI...

You can't do much better than that! Really nice job....I can't wait to see your progress and the final product. Thanks for keeping such a nice airplane flying!

All my best,
Rob

Good afternoon, Taylorman,

I've always been very fond of the PA-14s. A close friend of my Dad's had s/n 14-41 on EDO 2000s. My Dad loved it, and had he not had his Super Cub, he would have...

Good evening,

Can the PA-18 seat springs be removed without damaging them? Do the free ends need to be bent straight first?

Thanks in advance for any suggestions and experiences that can help.

Many years ago my Dad`s IA would put a light coat of oil on those areas and then clean it off before blasting when the time came to prime.

Thanks, Melanie!

Glad to hear everything is OK. Alwyas a pleasure to do business with you folks!

All my best,
Rob

Yesterday my call went to VM, but the mailbox was full and I couldn't leave a message.

Thanks so much for the input, gents. Much appreciated!

Good afternoon,

When you are installing the additional diagonal tube(s) in the overhead, do you jig the top rectangle to prevent distortion? Wings are not on the airplane.

Thanks in advance...

Good morning, Amy,

Thank you for taking the time to respond and provide the information above! Very much appreciated. I'm on travel until 11 May, but I'll reach out to Dan before then. I'm at a...

Good afternoon, all,

Historically, has Wipaire offered any special pricing during Oshkosh week for the PA-18 2,000 lb GW increase STC?

Thank you in advance for your input.

Best,
Rob

That really looks nice...I bet it does quiet things down a bit. Will they provide burn certs for the material? If not, is there an equivalent material you know of that I can use for a certified...