Search:

Type: Posts; User: BC12D-4-85

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. Replies
    13
    Views
    865

    https://www.supercub.org/forum/showthread.php?5903...

    https://www.supercub.org/forum/showthread.php?59034-New-piper-j5 Might be worth a look. Fine fun airplanes.

    Gary
  2. Replies
    45
    Views
    1,960

    Perhaps optical delusion but the tires appear...

    Perhaps optical delusion but the tires appear toed-out? Might be my eyes tho. Any fish nearby?

    Gary
  3. Replies
    36
    Views
    6,330

    Having that gap makes it convenient to oil the...

    Having that gap makes it convenient to oil the cross tube there, run the trim up and down plus sideways some, then resafety.

    Gary
  4. Replies
    13
    Views
    865

    Hey..If momma ain't happy ain't nobody...

    Hey..If momma ain't happy ain't nobody happy....They are available but for $40K? I'd make sure the tubing-fabric-engine...but you know all that. "It doesn’t have to be pretty just airworthy and not...
  5. Replies
    13
    Views
    865

    Yes the points for the -11 remain. Any owner...

    Yes the points for the -11 remain. Any owner flying legally needs to consider useful load versus fuel limited range. Like anything they weigh less when airborne apparently. Piper (or some...
  6. Replies
    13
    Views
    865

    Mike you're better than that. PA-11 GW 1220...

    Mike you're better than that. PA-11 GW 1220 conventional and 1300 to 1350 depending on EDO float model. STC'd floats maybe more. Long winter? But yes they are a single op and dog airplane as I...
  7. Replies
    89
    Views
    41,685

    Suziki, Yamaha, Honda, BMW, and other motorcycles...

    Suziki, Yamaha, Honda, BMW, and other motorcycles have offered variable exhaust valve flappers for years....EXUP valves Some's for noise reduction but the main reason is adding or subtracting exhaust...
  8. Replies
    42
    Views
    5,815

    Just tell the curious it's from a Cub that landed...

    Just tell the curious it's from a Cub that landed where you did once that had to be coptered out 'cause it was too short to takeoff

    Gary
  9. Remember: Pay Attention, and good flying! Gary

    Remember: Pay Attention, and good flying!

    Gary
  10. Replies
    42
    Views
    5,815

    Yes it's a small world isn't it? Lots of well...

    Yes it's a small world isn't it? Lots of well seasoned folks live here, especially for the summers. All well armed BTW. How much do you think cooling drag detracts from your speed? Or other stuff...
  11. Replies
    40
    Views
    3,397

    Unless you approach VFR or pass through IFR you...

    Unless you approach VFR or pass through IFR you don't. At least that's my experience about a FAR that's asking more than it provides. Go Class B criteria and make it 3 miles and clear of clouds. Plus...
  12. Replies
    40
    Views
    3,397

    Glassy water - drop the rudders and when they...

    Glassy water - drop the rudders and when they start banging you're getting close. That LIDAR gadget has lots of other uses. Make it rotatable and maybe someone will finally be able to actually...
  13. Replies
    42
    Views
    5,815

    Orange is easy to find if it decides to depart....

    Orange is easy to find if it decides to depart. The shape does fit the cowl's form nicely. I suppose in lieu of running and marking any spinner or backing plate offset just pulling some plugs and...
  14. Replies
    42
    Views
    5,815

    Here's one method I've seen for balancing. Normal...

    Here's one method I've seen for balancing. Normal prop bolt length limits washer numbers to achieve balance under head while maintaining thread penetration in the crankshaft flange. They are...
  15. Replies
    42
    Views
    5,815

    The prop folks I've seen do it look for wobble....

    The prop folks I've seen do it look for wobble. If noted they take a wood stick with a marker and quickly touch the spinner. Just a brief tap. Felt tip magic marker on the last job. Low engine speed...
  16. Replies
    24
    Views
    1,493

    And water in the crankcase from any combustion...

    And water in the crankcase from any combustion blow-by....pull the dipstick after a flight and note the steam when it's cold

    Gary
  17. Also inspect your carb heat/air filter box and...

    Also inspect your carb heat/air filter box and cable controls. Any carb heat that leaks by the flapper when cold air is selected will reduce performance and create a richer air/fuel mixture. The...
  18. On weaker gear like factory taylorcraft we have...

    On weaker gear like factory taylorcraft we have to be careful about toe-in, especially on hard ice with frozen raised patches. The raised patches can quickly force the ski nose sideways. The former...
  19. Replies
    42
    Views
    5,815

    If I can find them I try to use those softer...

    If I can find them I try to use those softer plastic, rubber, or fiber washers under the spinner screw heads. Helps reduce metal wear and over tightening which can eventually deform the spinner. I...
  20. Replies
    42
    Views
    5,815

    Prop balancers put a marker (soft chalk or felt...

    Prop balancers put a marker (soft chalk or felt ink sharpie) on a stick and briefly touch the spinner while running. Tells them where the offset part is so they can adjust by loosening the screws and...
  21. What advantage do skis with rubber bushings have...

    What advantage do skis with rubber bushings have over those with solid pedestals? I've flown both but never could figure out the benefit of Federal's design. Just asking those with more experience on...
  22. Another option might be to put an air intake...

    Another option might be to put an air intake adapter (or another in addition to the original) in that sump cover plate and feed the heater muff. I did that on a PA-11 with a similar opening and it...
  23. Jin offer CFI/CFII services via Alaska'a List and...

    Jin offer CFI/CFII services via Alaska'a List and Craigslist for Alaska. Look for the links. It takes time to learn Alaska flying plus gain the confidence of others. What better than doing that as an...
  24. I tried to post pics above but no luck. I did...

    I tried to post pics above but no luck. I did look up the C-170A Parts Manual and it shows what you describe, not what's in the C-170B Parts Manual for S/N 20267-25372. I'm corrected. The mufflers...
  25. Rich the figures 49-50 I see show otherwise -...

    Rich the figures 49-50 I see show otherwise - left carb; right cabin. Not arguing just looking at available figures in the link. Why not hook it up to feed the right muffler that flows better to the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4