bob turner

Oh, and to Dave's comment about Maule - one of the most interesting topics in Corporation Law is called "Piercing the Corporate Veil." Hiding the...

I don't know about experimental, but for the rest of us (not including mechanics) liability premiums are still quite low. Mine are $400/airplane,...

As an aside, we are using the smaller PC545 (Odyssey) in 85 hp J-3s. A brand new battery gets us over 70 starts. Two year old batteries easily get...

Agree. But it is easy - just have alternates on board. My Dceathlon carries wheel pants on/off variations. Really just an extra line or two on a...

I was only disagreeing about entering it in the logbook (or on a 337). We had one where the mechanic used mixed data (easy on a Super Cub, since...

Almost nobody does it that way any more, even on J-3s.

I usually agree with dga - but for Cubs and early Aeroncas, be aware that putting the aircraft on scales can turn it into 1PCLM. If you weigh it, do...

It used to be easy when Stits had approval for a fiber reinforced tape. This new polyester stuff will need to be pre- doped. I think the stuff I...

Not venting a battery (or anything else) in a Cub cockpit is impossible.

It’s just interesting thread drift. Been there . . .

I think the problem is that if your legs are short, the handle interferes with your knee and the stick on strong left crosswind landings. I...

You can measure the gear on the ground. Just use a tape measure and the tire treads - look for less than a half inch difference front to back. In...

I bought my Cub in 1962 -always maintained by a large repair shop. I gradually transitioned to owner maintenance, and in my first attempt to “clean...

Agree with Rob. For authority, see AC 23.27. Should be no problem with a competent IA.

Before you spend big bucks for a visit, get an agreement as to what will happen. If the owner cannot take you in the right seat for a quick flight...

Me too, although WD-40 makes fast work of grimy bellies. I posed the question to a model train buddy who happens to have a Ph.D in chemistry. His...

BasicMed was a Godsend. I am not sure I see much difference between that and LSA unless you have a really rigid family doctor. The drivers license...

Well, I found one:

There are a couple Cubs here that are truly stunning (opinion). I saved the photos, and shall now attempt to re-post them. I hope the copyright...

I think I agree with that. My Decathlon came with really flexible 2000-hr steel legs. I converted to aluminum, and feel quite a bit more secure. I...

I think I would fix that. Hard to believe a sealed strut would be elongated, but maybe the steel channels bolted to the wing? Easy to take it apart...

Any of those for the AMOC, if indeed they do an AD. Whatever they will approve. Even the rosettes will not require much fabric work if you TIG them.

Either way, this would save big bucks. If Steve can get the AMOC in a final AD so we can all use it, we would owe him big time! Weight...

I am comfortable signing off Univair struts with big forks if I first inspect them and find the Circle U. " Found Univair struts installed. ...

Some feds are genuinely helpful. We have two or three that would have granted my field approvals instantly. One ASI many years ago updated my CFI...

I was trying to get them to move an interfering frequency. I did not realize that it would cause a group of six feds to descend upon my hangar. One...

Difficult to believe it has been over a year since I updated. My FSDO still maintains that I cannot install these radios, and as recent as September...

Looks great! Stewarts? Clevelands?