View Profile: pzinck - SuperCub.Org

Tab Content: All; pzinck; Friends; Photos

Older Activity
Today, 06:17 AM

cruiser replied to a thread Suggestion for Stromberg repair - re-jet in Piper: PA-11 Cub Special (and L-18B)

Drip. Drip. Drip. Is there anyone on here that does not have a Champ or a Cub in a back hangar on their airport with gas stains down the cowling and...

see more

29 replies | 486 view(s)
Yesterday, 07:53 PM

cruiser replied to a thread Exhaust systems and Federal Skis in Modifications

Perhaps a piece of fire sleeve or other steel type sleeve would help mitigate that problem Randy.

see more

11 replies | 466 view(s)
01-17-2021, 02:05 PM

cruiser replied to a thread Mogas/HP/Compression/Timing/Operating Cost in Cafe Supercub

Not that I recall. The lawnmower story was a good one although it needed more mowers

see more

35 replies | 1335 view(s)
01-17-2021, 07:45 AM

cruiser replied to a thread Mogas/HP/Compression/Timing/Operating Cost in Cafe Supercub

A wise old fellow told me one time that if your gonna tell a bear story make sure there's lots of bears in it. This one needs more lawnmowers

see more

35 replies | 1335 view(s)
01-16-2021, 06:17 AM

cruiser replied to a thread Mogas/HP/Compression/Timing/Operating Cost in Cafe Supercub

The only benefit I have seen in going from an 0235 to an 0320 is the ability to purchase 2 gallons more per hour. I predict a painful cost increase...

see more

35 replies | 1335 view(s)
01-13-2021, 04:31 PM

cruiser replied to a thread Olibuilt 's New Cub project in Member Projects in Progress

Datum actuators are $500 each, American, at least for the 2000’s. Progressive Automations PA-10 that Oli bought are $179. The PA-17, rated at 800 lbs...

see more

586 replies | 210127 view(s)
01-11-2021, 05:34 PM

Tim replied to a thread Olibuilt 's New Cub project in Member Projects in Progress

good deal Oli, keep us posted on the actuators if they hold up Sent from my Pixel 2 using SuperCub.Org mobile app

see more

586 replies | 210127 view(s)
01-05-2021, 07:58 AM

cruiser replied to a thread Carbon Cub-Aileron Cable Wear in CubCrafters: CC18, CC11, CC19 Top Cub, Carbon Cub, and X-Cub

https://www.askbob.aero/content/aircraft-control-cable-comparison-wear-behavior-stainless-and-galvanized-carbon-steel

see more

25 replies | 3531 view(s)
12-28-2020, 07:46 PM

cruiser replied to a thread It's only a matter of time before they realize GA is still using leaded fuel in Cafe Supercub

The FAA PAFI initiative took a nose dive when Shell failed to meet the standards leaving Swift Fuel as the only viable supplier. IMO had Shell...

see more

22 replies | 1565 view(s)
12-21-2020, 05:37 AM

cruiser replied to a thread Removing Stains in Poly Tone in Cafe Supercub

Not a new problem.

see more

11 replies | 697 view(s)

No More Results

pzinck

Mini Statistics

More 2 Friends

Tim

cruiser

Recent Visitors

Basic Information

About pzinck

Contact

Statistics

Total Posts

General Information

2 Friends

cruiser

Tim