akavidflyer

I get 102-105 on a pacer on 31s, but I cruise at 2550. Next question, are you using mechanical tach or digital. I checked my mechanical tach at...

What kind of take off RPM are you getting?

A wrap or two of aluminum tape on the lower pitch pin. If you measure the diameter of the different pins, you can figure out in between pitches real...

What diameter are you running? If you are pulling the "new" 3 with 160 its gotta be a shorter prop, or you have one of the props that has the base...

Nitrogen is sometimes put in tires because it is inert and pressure won't change with temperature. I have seen a lot of boat trailers etc around...

I did state above that the pins can be machined down, I was the first to do it years ago to really fine tune the prop for my use. We have years...

While this might work for 180HP, it won't work for crap on the 150/160 HP engine. Local guy got his for a 150HP cub and the way the prop hub is...

If this was used only as a last resort to get out of somewhere you shouldn't be, I can see a benefit. I can also see a whole lot of guys who would...