akavidflyer

If you measure the steps in the pins, its pretty easy to have any machine shop make them. I turned down some of the higher pitch pins to make a 35.5...

So many questions. Tried the impossible turn? Glad they are ok but damn... Thats 2 CC that I know of in the last week and flying season is just...

With mine at 36.5 pitch (I turned my own pin) at 2500 and 1500' ASL MP bounces between 20.7 and 21. On take off at 2700 its 24.5 to 25 on the MP I...

at 5000-5900 RPM. Don't think that will translate well to the lycomings or cont..

funny, I have been running one for a couple years and love it. Lots of other people do as well. Can't really make that assumption based off...

There is a plethora of planes that only have the 2" numbers, mine included that pass annuals year after year, are seen at show after show etc. You...

if its vinyl, careful use of a heat gun helps to peel it off. You can also look up vinyl removal and most graphics places that do wraps have some...

Most of the cessna drivers I see at the local airport. They can log 10 landings on pretty much every landing.

I guess I was referring to the piper tachs. It's pretty rare from the 15 or so that we have tested when playing with the prop pitches that the piper...

Tru Tach. I have yet to see a mech tach that was accurate. Mine was off 250 RPM on the top end, others I have done were 150-250 RPM off (mech tach...