DENNY

The pressure relief ball is a quick and easy thing to check so starting there is a good Ideal. DENNY

How much time on the engine total and how long since bottom end was open? Do you have a screen or oil filter? Is it still making metal? At what...

Depending on the 160 hp cub a 82/43 Borer should get you around 90 MPH at 2400 RPM. You will loose/gain about 2 1/2 MPH per inch of pitch change....

Depending on plane, engine, and mission the Borer is the gold standard in Alaska!! So what plane/engine/mission do you have in mind. A 160 HP is...

watch DENNY

Troy I think the video is very deceiving, I believe he took off on the SE runway and the video starts after he was off the water. Load was six...

I prefer a bit tighter suspension even light. People tend to get used to what ever they have after a few landings. DENNY

Call Gabe on monday. 907-331-4480 He follows the forum so he will be able to see the pictures. They have great customer service so I am sure he...

Oil will bypass the filter media in case the media becomes clogged or oil is to thick to flow through it properly. DENNY

Not all Square tip wings are make the same. One STC has you cutting back the front spar to match the rear length so overall you will loose some wing...

Read the article StewartB posted for proper leaning. Everybody is right, every body is wrong, just depends on altitude.:lol: DENNY

Cubflier beat me to it. Loose float bowl would be my number 1 guess, look for blue stains on the side of the float bowl. Could also be a leaking...

Sooooooo!!! If the mission is going to places to provide medical evacuation to people in an emergency that is not the proper wingtip!!!!!! I am all...

2 inches of blue board under the concrete and in floor heat will pay for itself in a very short time. DENNY

The Terrain feature in a Garmin 795 GPS is an invaluable asset when scud running in hills/mountians. You can tell if you have enough altitude to...

So how do we stop the cycle of new pilots killing themselves? CFI's have only so much time to teach the basics of flying, mostly because pilots are...

You need to describe everything that is happening when you fly final or we will be trying to figure this out over the next two weeks. It sounds like...

Cubflier, Thanks for looking that one up. I had seen that several times before, just wasn't sure which post it was in. Cold winter nights are...

Unless you have had proper stall spin training you have reached you level of expertise and should have someone that is capable of spinning a plane to...

Sounds like you are running lean. How does your oil temp respond if you do not lean? How much RPM drop do you get when you pull carb heat at 2400...

Make the attachment points removable and the jig a bit oversize it will fit 18, 12, 18 wide body, 4 place. Just add in proper attachments. DENNY