DENNY

They do make a lapping compound for soft metal. I have not tried it so advice is worth what you paid for it. ...

Welcome You will find a lot of great info on this site. Where are you located? One thing to think about early is what is the mission for the...

That looks to be a highly modified 12. Cub gear/tail, flaps, left side door, bushwheel/garr arrow tailwheel, suspect bigger engine. DENNY

On my first cup of coffee but real cheap and quick HP can be had by using a prop that will let it turn 2700 on static run up:wink: Just keep an eye...

The current model does not have a tracking program. I think the Garmin InReach is currently the best deal when it comes to tracking. DENNY

AVECMO is a great company. Prices did not go up on my cub last year. DENNY

That entire tailwheel you have should be a pretty big drag issue. You might want to start with simple stuff like not flying with the toe bar...

When I am training for STOL comp I can usually do a pattern with full stop in 3 1/2 min. After 1/2 hour ADD kicks in and I stop or go to some high...

A short strip should not need any longer setup then a long one if you have good technique. A three mile 747 approach is of little use in a cub....

Go back to math class. One landing every 10 seconds is 360 in one hour. With your math it would only take 5 hours for 1800 landings. DENNY

So are you going to have to lift you foot off the rudder pedal and move it up on top of the bump to apply brakes? DENNY

Do a mag check at 2200 and 2400 might have a bad plug that fires well at sunup but cuts out at higher RPM. If you have slick mags recheck the...

The best way to make sure you do not fly for 6 -24 months is to just do simple fabric job with a few upgrades. Save money as you fly this one, when...

It might just be the angle of the picture but it looks like you will always be applying brake with any rudder application? DENNY

Some of the 0320 engines come stock from Lycoming with Dual impulse slicks. DENNY

Is there a bushing in the top holes of CC cabane V? Seems I remember hearing/reading about something like that. Hole looks kind of big in the...

Tie the tail down and get a static RPM so you have a baseline to start with. With an 82 inch prop in general every inch change in the prop will cost...

I put some thin windows in mine so I had the same issue. I took a set of channel lock pliers and put a squeeze on channel, that helped a lot. DENNY

The crust cutter is attached from the distal end of the spring to the tip of the ski. The cable running from the ski through the spring to the...

It is pretty easy to fly a cub with just trim, rudder, and throttle. I would not like to land with only that but that is why I keep a leatherman...

If you do a search on 18A cubs you will find several posts on converting from a sprayer to a two seat plane. If yours has the correct paperwork and...

I have run a blended mix with usually 1/3 LL in mine for years with no problems. I do not store fuel in it for long periods. I usually fill bag day...