DENNY

For the people that worry about weight a Six bolt magnesium 11/4 wheel/rotor/brake is 2 1/2 lighter per side than a 11/2 3 bolt wheel/rotor/brake. ...

You may run into an issue with the holes lining up on the ginger bread once you hang a motor on the fuselage. The frame will flex a bit so you might...

Here ya go. https://www.pipistrel-aircraft.com/aircraft/electric-flight/alpha-electro/ DENNY

I think electric aircraft are going to be the trainer of the future. One they start showing up rapid charge stations will be close behind. A lot...

That is what I use. Sometimes you have to do a double kick of the rudders to lock it back up when it's cold. I prefer no slack in my chains but...

I will have to look but I think I am using the Aeroshell 22 DENNY

My friends would love it if I had one when I am lead, I tend to fly like a drunk sailor most of the time just because I like to look at stuff. I am...

What fuel injection system do you have? Yes an intake leak can cause a problem depending on the system. I would expect temps to be different for...

If the demand was that great for GA flying in the area it would have happened with the current available certified aircraft. Putting the word STOL...

When was overhaul done? DENNY

I would do #3 you could also try a small rounded edge cover on the upper sharp edge to reduce turbulence. DENNY

I would consider starting with certified aircraft. It is not that hard to find a certified aircraft for 1/3 or less the price of a kit built...

Most of the medical people I know don't do it for the money!! They do it because it is their profession. Do you really think they went out just to...

Dave When you say the 0320 flys slower, are you talking stall speed? Or attitude on approach (see it, feel it)? With Dougs math we added roughly...

Bill Thanks for jumping in. I know you are good at documenting what is really happening so appreciate your input. So with your 0360 you did not...

Skywagon/Doug Thanks for the feedback, having seen Doug fly I can say I have to work hard to keep up with him in his 12. Like I said I am not...

If you are going experimental I would not do a Dakota wing. They have excellent parts, stout as hell and will fit most any cub wing. Great for a...

So did the plane fly slower or was it just a mushing stall vs clean break? I understand it does not reduce downforce (unless you trim nose down),...

I guess I have 2 questions. Why not just trim as needed instead of adding weight to the tail? Downforce from the stabilizer will do the same thing...

That is the knot I use also, I was a sailor in a previous life so I knew how to tie knots and the first time I saw it I was skeptical but it does...

As with most things in life nothing is right 100 percent of the time. Sooooo if you end up on loose sand get out the shovel (part of the emergency...

The flap handle in a cub and a pacer both suffer from the same issue the Cessna has, having to bend down to reach the handle. Not really an issue on...

Arctic wire and rope is the best price I have found in Anchorage. If I was in the lower 48 I would do amazon. DENNY

I buy duckbills 30 at a time so I get a bit of a discount. I make up sets of 3 and put in plastic ziplock bags. The final cost is 25 dollars a set,...

I think the Canada system is going to be satellite based, so if you want to interface with it make sure you have a system that can handle both. ...