DENNY

Ya have have an A&P/IA in the area that can do a simple point change and internal timing on a slick mag? I have one on the shelf in the hanger you...

You problem is the left mag. It should start and run on the left mag alone. Your right mag is grounded when you are trying to start that is why it...

It is some extra work but if you take the time to hang and rig the wings/tail/thrustline now you will find any major alignment issues that need...

I will start with a safety note for all not sure if it applies in this case because you did not say if the prop was turning. Don't pump the throttle...

I have not flown the CC VGs but I think that tail strake work be a pain moving a cub around. I have the micro VGs and am very happy with them. DENNY

Insurance fraud is a real thing. Pretty easy to find a derelict aircraft, maybe one already damaged, set it out in hail country and make a claim...

NOS parts are usually worth a lot more than the used stuff espically ribs!! Go to aircraft spruce and look up what prices are for spars and anything...

Aircraft are certified to fly within certain parameters. Stay within them and trim for hands off flight and most all fly just fine especially with a...

I am involved with experimental and certified aircraft. Both have the same issues with prospective buyers. Does the plane fit the buyers mission!! ...

Using cow manure/human waste for Methane production has been around for a long time. First one was in 1859 a Leper colony in Bombay. It can be done...

OK the question is much clearer! Trying to build a cub or any part for that matter without knowing who will buy it is very difficult. I would only...

https://www.supercub.org/forum/showthread.php?51861-Drawing-for-Firewall-Mounted-Crankcase-Vent-tube DENNY

It all depends on the mission! Is it a long range heavy hauler with minimal fuel support? Floats? STOL monster? All will do well with a flipped...

Still dark out and I got me some coffee so just some general pontification. My panel has all the switches on the bottom like Skywagons. So far I...

If you are going to have autopilot I suspect you will also have 4 cylinder EGT/CHT monitor. This is very important in all planes but especially in...

I needed more nose up trim when I went from 31 to 35 in Bushwheels so that should help. Gap seals in the tail help with trim authority at slower...

This is the best explanation of the proper caster angle I have seen. If you do a search someone posted a diagram of the arch somewhere. I made one...

I prefer Felt baffling, but if done correctly the silicone will work fine. Neither work well if done incorrectly!! Get a good light and look...

Putting the ski on and off the tailwheel when you repack the tailwheel bearing can be a bit of a challenge. Talk with Burl about any clamps or...

My understanding is one of the reasons for the Stroker STC was availability of the crankshaft. The reason no HP increase was noted although present...

Welcome! This is one of the best places for information you can find (other than the manual) Use the Search function at the top right of the page...

Ya, I read the same one. I stoped in to talk to him about support for the AOSS shocks he said if no one buys him out he will keep doing it as a...

When I talked to him last year he said he was not leaving until January. Did you call the shop? DENNY

I love my EI gauges, they work great and the support is first class. My fuel flow was acting funny and I called to get recommendations figuring the...

Called grove this morning. They do not have any of the Grove 10 in rims 28-1027B in stock plans on doing a run in early next year they will put you...

The only thing constant in life is change! Most people don't think of Alaska city having problems with smog and air pollution but Fairbanks is one...