akmarty

How are the temps at full rich? My o360 has the 4064-1 carb because the jets are bigger than the other (3878 I think) carb. Sent from my iPhone...

Like fancypants mentioned the Aera bare wire harness wires are TINY. Planning to rewire and incorporate a multi pin plug to bundle the wires for...

At about 30hrs and have had no barrel issues. Had 2 bad EGT probes that should be covered by warranty (both eventually read ambient temp and tested...

I’m with the gubmint and I’m here to help you… Sent from my iPad using SuperCub.Org

Settings all match yours. Continuity test the connections tomorrow. Sent from my iPhone using SuperCub.Org

Still not having any success getting the gps data to the cgr. I’d greatly appreciate if any of you wouldn’t mind taking a look at your interface on...

From Artex manual… Sent from my iPhone using SuperCub.Org mobile app

The Aera 660 has NMEA 4800/9600 baud. Artex tech support said it needs to be “Aviation In” at 9600 baud vs NMEA 9600 Sent from my iPhone using...

Anyone use the Artex 345 with an Aera 660 for gps data? Did you have to “special order” to have it programmed for 4800 baud or does one of the...

My recent build was the o-360-a1a also. Used the Rubbert STC. Very pleased so far at 24 hrs on the engine and stc components. Exhaust is a...

Any engine monitor data to look at? Sent from my iPhone using SuperCub.Org

He also suggested using Fast as it gives better update rate for FOD and time. 9600 baud. Also stated that the MapMx is faster than the 9600 baud. ...

Spoke to the rep at EI booth today at the Gathering. He suggested that I try the moving map or MapMx for gps data and to use the FF1 or RNAV-FF for...

I’ll be back at the plane today and take pics of the options. Sent from my iPhone using SuperCub.Org

These are the available options in the Aera interface menu. Sent from my iPhone using SuperCub.Org mobile app

Does anyone have the correct settings for an Aera 660 to talk to the CGR-30p? Need the interface settings in the Aera. Thanks Marty Sent...