wireweinie

I'm curious about the re drilling, too. Will you have access to the tube or does the faa have pics? Web

Agreed. I keep hearing these claims about EathX, yet I only know of one incident and it smoked the first time it was powered up. THAT leads me to...

Don't worry. Steel adel clamps work well even after welding and paint/powder coat. Web

That's what on/off switches are for. Keep each light/system on it's own control switch and choose what to turn on or off and when to do it. Great...

Kind of subjective, but find a spec on lumens or candelas. Higher that number the brighter the light was as measured by a test rig. Poor mans way is...

Yes, and while cranking. Web

? Web

Like paying the mob. Just the cost of doing business. Web

Extra fun then. Use a piece of 20 gauge, three conductor, shielded wire for the nav/strobe combo. It has the effect of routing in one wire...

Is your rudder stripped down right now or does it have fabric on? Web

I don't see a specific mention of a rapid fire pattern in the specs. Either way, I doubt it would matter even if synch'd with the Orions. Why not...

When you call them, let the owner know that his namesake nephew highly recommends his shop. :lol: Web

What Mr. Pierce said. If you're replacing steam gauges, you are removing p-leads, tach cable, and any hoses, so you are going to have holes to...

Is that the correct model number? Web

Doesn't matter if the original gauge was direct sensing or electric. The CGR comes with it's own pressure transducer. Mount this in any convenient...

Oh, and don't pull the protective paper off the new windshield until it is completely installed. lol Web

In addition to the above advice, sand/polish the edges before final install to prevent cracking in the future. Also, I've had good results drilling...

I'd like to point out that beacons are not a required item. The rudder was not designed to hold a beacon, so don't install one. To conform to the...

Always make my own harnesses, but, that's part of my business, lol. Internal antennas work best in wood or non conductive composite aircraft. Ferrous...

I'm not sure it's been stated forcefully enough, here; IF YOU HAVE A US CERTIFICATED AIRCRAFT - A replacement data plate must be obtained from the...

Momentary thread hijack; Giangab, what are your local requirements for electrical equipment? Starter & alternator? Lights? Avionics equipment? ...

This is the drawing showing the lower end of the stick. A short section is expanded to fit over the stub, mounted on the torque tube. Web

Your aircraft is not registered as a U.S. aircraft, correct? If not, FAA rules about obtaining a replacement data plate would not apply. Web

The OP does not fall under FAA rules. Web