wireweinie

Pull it through and listen for the impulse coupling. When I installed them, I always recommended the 'bush kit' specifically for hand propping. It's...

What starter is on the engine right now? And what was the scenario where you found the drive gear engaged? I ask because the old school starters use...

It most likely starts because they installed a left mag with an impulse coupling. Champion Aerospace called this their 'Bush Kit'. It allows you to...

Pull the circuit breaker that powers the brain box. Everything reverts to standard magneto functions. Web

To set LASARs, they first require base timing setting. They are, in effect, a slick mag with electronics installed. After base time is set, then a...

Google up 'fleet shadower'. Same idea, new angle. Web

Glacier has it on the shelf. Web

Flo-Ex Web

More like 'somewhat conductive'. The easiest ground plane for a composite panel is either a piece of stainless screen or a star made of aluminum...

Did they actually mount the flat base of an antenna directly on a fold line? I'm obviously no structural expert, but how was that supposed to work?...

Technically, if the pod is non conductive and is not loaded with anything that is, the antenna should work correctly. But the loads never work out...

Nothing special order. If anything needs changed it will be the serial programming in the 660. Just look under 'Interfacing' in the manual. Web

If this is an ongoing issue for you guys operating in extreme cold, you can use a 'split battery' system for startup. In it's most basic design, two...

This is a job for your mechanic unless he agrees to sign off your work. Web

What is more comfortable for you? Same with length of stick; is it tall/short enough for you to fly comfortably and hit the stops? Web

It needs to be on the outside for best function. Can you just mount it where the existing antenna is? Your wallet. But remember that if you use a...

Wow! Detained pending trial. Web

Throw the KY97A back in. It may not look fancy but it's a much better quality radio. Web

Check your master switch with an ohm meter. See if the continuity varies when you wiggle the switch. Then check the field and output breakers for any...

Hey Doc Was this wired for the A210 or was it wired for something else originally? You should be able to put a KY97A in that tray but the...

It's the radio. The last decent one that Icom made for aviation was the -A200. Web

Ok. For you it connects to the toggle switches. I was waiting for this. Web

Electronics International. Power & ground wires and two sensing leads that connect to the key switch. Then remove the drive cable and throw it away....

The Whelen 70509 will be the lightest unit and no special power supply required. I don't recommend a beacon if strobes are already installed and with...

Sometimes simple is better. A typical master or start relay isn't much heavier (if at all) than a solid state relay with the heat sink necessary at...

If you operate around other aircraft or in dusty/foggy conditions, you'll want to switch off the strobes but keep the navs on. Web