Page 1 of 28 12311 ... LastLast
Threads 1 to 50 of 1390

Forum: Tips and Tricks

Little (and big) Tidbits for your Cub

  1. tools, jigs, fixtures, and other neat stuff

    Started by mike mcs repair, 09-04-2010 01:58 PM
    17 Pages
    1 2 3 ... 17
    • Replies: 642
    • Views: 296,195
    12-04-2019, 11:30 AM Go to last post
  2. Best epoxy to bond aluminum

    Started by C-YQK, 11-14-2019 01:31 PM
    • Replies: 24
    • Views: 1,055
    11-18-2019, 04:22 AM Go to last post
  3. found a mag oozing puss!

    Started by astjp2, 11-18-2019 12:08 AM
    • Replies: 0
    • Views: 326
    11-18-2019, 12:08 AM Go to last post
  4. Need advice choosing tire size.

    Started by RandyZ, 11-05-2019 01:54 PM
    • Replies: 27
    • Views: 1,693
    11-17-2019, 02:03 PM Go to last post
  5. Fuel Flow Indication Abnormality

    Started by Steve Pierce, 11-09-2019 09:29 AM
    • Replies: 10
    • Views: 306
    11-09-2019, 01:05 PM Go to last post
  6. Extended Leading Edge rib stitching

    Started by skywagon8a, 11-29-2009 04:27 PM
    2 Pages
    1 2
    • Replies: 44
    • Views: 11,657
    11-06-2019, 08:59 PM Go to last post
  7. Aerial seeding?

    Started by cgoldy, 03-24-2014 06:42 PM
    • Replies: 19
    • Views: 3,696
    11-05-2019, 08:35 AM Go to last post
  8. removing shock cords from PA-12

    Started by Larry Huntley, 05-15-2018 09:01 AM
    • Replies: 36
    • Views: 6,201
    11-04-2019, 09:29 PM Go to last post
  9. removing floats and fitting wheels.

    Started by ron, 10-29-2019 04:07 PM
    • Replies: 10
    • Views: 728
    11-03-2019, 06:32 PM Go to last post
  10. SAE 50# felt

    Started by Beaverpilot, 10-28-2019 07:02 PM
    • Replies: 3
    • Views: 515
    10-30-2019, 10:06 PM Go to last post
  11. Stabilizer/Elevator rigging

    Started by giangab, 11-08-2018 03:56 PM
    2 Pages
    1 2
    • Replies: 41
    • Views: 4,706
    10-30-2019, 08:08 PM Go to last post
  12. How many of you ohm your spark plugs?

    Started by astjp2, 10-24-2019 03:56 PM
    • Replies: 20
    • Views: 1,194
    10-28-2019, 06:55 PM Go to last post
  13. Plucking the wings

    Started by MidCoastCub, 10-27-2019 09:29 AM
    • Replies: 15
    • Views: 812
    10-28-2019, 01:19 PM Go to last post
  14. Rear Stick Boot

    Started by Steve Pierce, 10-25-2019 06:19 PM
    • Replies: 7
    • Views: 454
    10-25-2019, 08:44 PM Go to last post
  15. Magneto Drive Gear

    Started by J4coupe, 06-28-2019 02:22 AM
    • Replies: 16
    • Views: 1,247
    10-25-2019, 09:32 AM Go to last post
  16. Slick Mag SB1-19

    Started by skywagon8a, 04-11-2019 02:01 PM
    • Replies: 1
    • Views: 727
    10-24-2019, 05:36 PM Go to last post
  17. Scott 3200 Taiwheel refurbishment

    Started by Binty, 05-15-2011 03:12 AM
    3 Pages
    1 2 3
    • Replies: 91
    • Views: 29,102
    10-24-2019, 05:34 PM Go to last post
  18. Big Tires

    Started by JWE, 09-06-2019 06:23 PM
    • Replies: 14
    • Views: 2,830
    10-05-2019, 11:41 AM Go to last post
  19. PA12 Muffler Shroud Removal Problem

    Started by Paul Heinrich, 09-08-2019 10:10 PM
    • Replies: 5
    • Views: 903
    09-11-2019, 11:59 PM Go to last post
  20. PA 18/95 short TO & L

    Started by giangab, 09-05-2019 01:24 AM
    • Replies: 10
    • Views: 1,023
    09-06-2019, 01:16 AM Go to last post
  21. Scott 3200 Bearings

    Started by HandsSlowLow, 04-02-2011 01:58 PM
    2 Pages
    1 2
    • Replies: 52
    • Views: 22,774
    09-02-2019, 07:49 AM Go to last post
  22. Instruments for rear seat pax/pilot

    Started by giangab, 08-15-2019 01:13 PM
    • Replies: 26
    • Views: 3,191
    08-17-2019, 06:42 AM Go to last post
  23. Fuel Tank Installation Question

    Started by planenuts, 06-25-2019 07:50 AM
    • Replies: 4
    • Views: 710
    06-26-2019, 08:47 AM Go to last post
  24. Hidden U-Channels

    Started by robertc, 06-05-2019 12:27 PM
    • Replies: 0
    • Views: 499
    06-05-2019, 12:27 PM Go to last post
  25. Ipad aux power

    Started by 5CT7, 04-29-2019 04:54 PM
    • Replies: 17
    • Views: 1,176
    05-01-2019, 06:56 AM Go to last post
  26. Good friend

    Started by cubdriver2, 04-18-2019 12:41 AM
    • Replies: 11
    • Views: 1,942
    04-21-2019, 07:40 PM Go to last post
  27. PA-12 Leveling

    Started by barkerlongez, 01-19-2004 01:05 PM
    • Replies: 14
    • Views: 5,821
    04-20-2019, 05:27 PM Go to last post
  28. New primer product

    Started by stewartb, 04-03-2019 10:13 PM
    • Replies: 11
    • Views: 1,710
    04-09-2019, 12:34 AM Go to last post
  29. Swing your compass?

    Started by bob turner, 04-01-2019 06:03 PM
    • Replies: 24
    • Views: 1,730
    04-03-2019, 07:54 PM Go to last post
  30. Fuel shut off valve

    Started by Tim, 03-27-2019 06:18 PM
    • Replies: 17
    • Views: 1,599
    03-29-2019, 11:49 PM Go to last post
  31. Oiling Fuselage Tubes

    Started by markc, 05-12-2004 07:32 PM
    2 Pages
    1 2
    • Replies: 62
    • Views: 15,788
    03-23-2019, 01:22 PM Go to last post
  32. Painting question

    Started by Beaverpilot, 02-09-2019 02:52 PM
    • Replies: 13
    • Views: 2,648
    03-04-2019, 07:45 PM Go to last post
  33. Belly and side stringer question

    Started by Beaverpilot, 03-02-2019 10:43 PM
    • Replies: 5
    • Views: 1,080
    03-04-2019, 12:41 AM Go to last post
  34. Cool stuff

    Started by cubdriver2, 02-24-2019 09:19 AM
    • Replies: 0
    • Views: 830
    02-24-2019, 09:19 AM Go to last post
  35. Ideas to silence an Air Compressor?

    Started by Marty57, 02-01-2019 11:42 AM
    2 Pages
    1 2
    • Replies: 41
    • Views: 4,507
    02-21-2019, 09:25 PM Go to last post
  36. Zenair floats for experimental supercub

    Started by Clifford, 04-20-2012 07:28 PM
    • Replies: 32
    • Views: 8,377
    02-02-2019, 01:54 AM Go to last post
  37. Cleaning Aluminum with Soda Blaster, Question

    Started by Kahles56, 01-10-2019 11:12 AM
    • Replies: 8
    • Views: 2,062
    01-11-2019, 08:01 AM Go to last post
  38. Low cost Hydroforming

    Started by jimboflying, 01-10-2019 11:10 PM
    • Replies: 3
    • Views: 1,423
    01-10-2019, 11:53 PM Go to last post
  39. Flap leading edge fab

    Started by jimboflying, 01-02-2019 10:39 PM
    • Replies: 6
    • Views: 1,625
    01-10-2019, 11:01 PM Go to last post
  40. How to jack up a Cub

    Started by windy, 08-30-2018 07:42 PM
    • Replies: 30
    • Views: 6,387
    01-09-2019, 10:56 AM Go to last post
  41. Tool For Replacing Elevator and Rudder Bushings

    Started by Steve Pierce, 09-20-2011 02:24 PM
    2 Pages
    1 2
    • Replies: 65
    • Views: 18,806
    01-08-2019, 11:50 AM Go to last post
  42. Shaving tires

    Started by Aerotow1, 01-04-2019 11:37 AM
    • Replies: 14
    • Views: 2,530
    01-06-2019, 09:42 AM Go to last post
  43. Carb temp port plug on MA4 carb.

    Started by badmdcnman, 01-03-2019 09:28 PM
    • Replies: 2
    • Views: 1,100
    01-04-2019, 07:39 AM Go to last post
  44. Battery position PA18-95

    Started by giangab, 10-29-2017 12:55 PM
    • Replies: 13
    • Views: 4,262
    12-12-2018, 04:52 PM Go to last post
  45. Areomatic Propellers question

    Started by Kahles56, 12-07-2018 10:42 PM
    • Replies: 11
    • Views: 2,115
    12-11-2018, 05:57 AM Go to last post
  46. Earthquake

    Started by PA-12 on Baumanns, 11-30-2018 07:10 PM
    • Replies: 2
    • Views: 1,713
    12-06-2018, 04:51 PM Go to last post
  47. Electric Chain Hoist. Anyone have a favorite?

    Started by stewartb, 10-22-2018 10:42 PM
    • Replies: 22
    • Views: 3,959
    11-20-2018, 10:23 PM Go to last post
  48. Control Surface Rotator for Painting

    Started by robertc, 11-09-2018 11:09 PM
    • Replies: 0
    • Views: 1,364
    11-09-2018, 11:09 PM Go to last post
    • Replies: 18
    • Views: 4,712
    10-14-2018, 09:18 PM Go to last post
    • Replies: 0
    • Views: 1,252
    10-11-2018, 09:31 AM Go to last post

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •