Page 1 of 28 12311 ... LastLast
Threads 1 to 50 of 1381

Forum: Tips and Tricks

Little (and big) Tidbits for your Cub

  1. tools, jigs, fixtures, and other neat stuff

    Started by mike mcs repair, 09-04-2010 01:58 PM
    16 Pages
    1 2 3 ... 16
    • Replies: 619
    • Views: 288,450
    10-12-2019, 09:15 PM Go to last post
  2. Big Tires

    Started by JWE, 09-06-2019 06:23 PM
    • Replies: 14
    • Views: 2,016
    10-05-2019, 11:41 AM Go to last post
  3. PA12 Muffler Shroud Removal Problem

    Started by Paul Heinrich, 09-08-2019 10:10 PM
    • Replies: 5
    • Views: 449
    09-11-2019, 11:59 PM Go to last post
  4. Scott 3200 Taiwheel refurbishment

    Started by Binty, 05-15-2011 03:12 AM
    3 Pages
    1 2 3
    • Replies: 85
    • Views: 27,762
    09-06-2019, 11:05 AM Go to last post
  5. PA 18/95 short TO & L

    Started by giangab, 09-05-2019 01:24 AM
    • Replies: 10
    • Views: 768
    09-06-2019, 01:16 AM Go to last post
  6. Scott 3200 Bearings

    Started by HandsSlowLow, 04-02-2011 01:58 PM
    2 Pages
    1 2
    • Replies: 52
    • Views: 22,286
    09-02-2019, 07:49 AM Go to last post
  7. Instruments for rear seat pax/pilot

    Started by giangab, 08-15-2019 01:13 PM
    • Replies: 26
    • Views: 1,609
    08-17-2019, 06:42 AM Go to last post
  8. Aerial seeding?

    Started by cgoldy, 03-24-2014 06:42 PM
    • Replies: 12
    • Views: 2,741
    07-09-2019, 04:23 PM Go to last post
  9. Magneto Drive Gear

    Started by J4coupe, 06-28-2019 02:22 AM
    • Replies: 14
    • Views: 955
    07-09-2019, 02:27 PM Go to last post
  10. Fuel Tank Installation Question

    Started by planenuts, 06-25-2019 07:50 AM
    • Replies: 4
    • Views: 665
    06-26-2019, 08:47 AM Go to last post
  11. Hidden U-Channels

    Started by robertc, 06-05-2019 12:27 PM
    • Replies: 0
    • Views: 448
    06-05-2019, 12:27 PM Go to last post
  12. Ipad aux power

    Started by 5CT7, 04-29-2019 04:54 PM
    • Replies: 17
    • Views: 1,083
    05-01-2019, 06:56 AM Go to last post
  13. Good friend

    Started by cubdriver2, 04-18-2019 12:41 AM
    • Replies: 11
    • Views: 1,867
    04-21-2019, 07:40 PM Go to last post
  14. PA-12 Leveling

    Started by barkerlongez, 01-19-2004 01:05 PM
    • Replies: 14
    • Views: 5,683
    04-20-2019, 05:27 PM Go to last post
  15. Stabilizer/Elevator rigging

    Started by giangab, 11-08-2018 03:56 PM
    • Replies: 36
    • Views: 3,972
    04-13-2019, 11:41 AM Go to last post
  16. Slick Mag SB1-19

    Started by skywagon8a, 04-11-2019 02:01 PM
    • Replies: 0
    • Views: 529
    04-11-2019, 02:01 PM Go to last post
  17. New primer product

    Started by stewartb, 04-03-2019 10:13 PM
    • Replies: 11
    • Views: 1,630
    04-09-2019, 12:34 AM Go to last post
  18. Swing your compass?

    Started by bob turner, 04-01-2019 06:03 PM
    • Replies: 24
    • Views: 1,629
    04-03-2019, 07:54 PM Go to last post
  19. Fuel shut off valve

    Started by Tim, 03-27-2019 06:18 PM
    • Replies: 17
    • Views: 1,499
    03-29-2019, 11:49 PM Go to last post
  20. Oiling Fuselage Tubes

    Started by markc, 05-12-2004 07:32 PM
    2 Pages
    1 2
    • Replies: 62
    • Views: 15,401
    03-23-2019, 01:22 PM Go to last post
  21. Painting question

    Started by Beaverpilot, 02-09-2019 02:52 PM
    • Replies: 13
    • Views: 2,541
    03-04-2019, 07:45 PM Go to last post
  22. Belly and side stringer question

    Started by Beaverpilot, 03-02-2019 10:43 PM
    • Replies: 5
    • Views: 1,017
    03-04-2019, 12:41 AM Go to last post
  23. Cool stuff

    Started by cubdriver2, 02-24-2019 09:19 AM
    • Replies: 0
    • Views: 775
    02-24-2019, 09:19 AM Go to last post
  24. Ideas to silence an Air Compressor?

    Started by Marty57, 02-01-2019 11:42 AM
    2 Pages
    1 2
    • Replies: 41
    • Views: 4,334
    02-21-2019, 09:25 PM Go to last post
  25. Zenair floats for experimental supercub

    Started by Clifford, 04-20-2012 07:28 PM
    • Replies: 32
    • Views: 8,255
    02-02-2019, 01:54 AM Go to last post
  26. Cleaning Aluminum with Soda Blaster, Question

    Started by Kahles56, 01-10-2019 11:12 AM
    • Replies: 8
    • Views: 2,007
    01-11-2019, 08:01 AM Go to last post
  27. Low cost Hydroforming

    Started by jimboflying, 01-10-2019 11:10 PM
    • Replies: 3
    • Views: 1,383
    01-10-2019, 11:53 PM Go to last post
  28. Flap leading edge fab

    Started by jimboflying, 01-02-2019 10:39 PM
    • Replies: 6
    • Views: 1,582
    01-10-2019, 11:01 PM Go to last post
  29. How to jack up a Cub

    Started by windy, 08-30-2018 07:42 PM
    • Replies: 30
    • Views: 6,159
    01-09-2019, 10:56 AM Go to last post
  30. Tool For Replacing Elevator and Rudder Bushings

    Started by Steve Pierce, 09-20-2011 02:24 PM
    2 Pages
    1 2
    • Replies: 65
    • Views: 18,509
    01-08-2019, 11:50 AM Go to last post
  31. Shaving tires

    Started by Aerotow1, 01-04-2019 11:37 AM
    • Replies: 14
    • Views: 2,475
    01-06-2019, 09:42 AM Go to last post
  32. Carb temp port plug on MA4 carb.

    Started by badmdcnman, 01-03-2019 09:28 PM
    • Replies: 2
    • Views: 1,068
    01-04-2019, 07:39 AM Go to last post
  33. Battery position PA18-95

    Started by giangab, 10-29-2017 12:55 PM
    • Replies: 13
    • Views: 4,143
    12-12-2018, 04:52 PM Go to last post
  34. Areomatic Propellers question

    Started by Kahles56, 12-07-2018 10:42 PM
    • Replies: 11
    • Views: 2,067
    12-11-2018, 05:57 AM Go to last post
  35. Earthquake

    Started by PA-12 on Baumanns, 11-30-2018 07:10 PM
    • Replies: 2
    • Views: 1,680
    12-06-2018, 04:51 PM Go to last post
  36. Electric Chain Hoist. Anyone have a favorite?

    Started by stewartb, 10-22-2018 10:42 PM
    • Replies: 22
    • Views: 3,871
    11-20-2018, 10:23 PM Go to last post
  37. Control Surface Rotator for Painting

    Started by robertc, 11-09-2018 11:09 PM
    • Replies: 0
    • Views: 1,337
    11-09-2018, 11:09 PM Go to last post
    • Replies: 18
    • Views: 4,548
    10-14-2018, 09:18 PM Go to last post
    • Replies: 0
    • Views: 1,224
    10-11-2018, 09:31 AM Go to last post
    • Replies: 16
    • Views: 3,667
    10-04-2018, 06:27 PM Go to last post
  38. prop rpm

    Started by skybolt64, 02-17-2016 08:45 PM
    • Replies: 30
    • Views: 11,390
    09-22-2018, 05:23 PM Go to last post
  39. Lumber without a rack?

    Started by TurboBeaver, 09-14-2018 11:43 AM
    • Replies: 15
    • Views: 3,388
    09-19-2018, 11:01 AM Go to last post
  40. Titan Straps

    Started by stewartb, 09-13-2018 08:56 AM
    • Replies: 12
    • Views: 2,970
    09-17-2018, 12:44 PM Go to last post
  41. Gojacks

    Started by stewartb, 09-03-2018 09:12 AM
    • Replies: 10
    • Views: 2,832
    09-13-2018, 04:31 PM Go to last post
  42. Torquing prop bolts

    Started by Oliver, 08-20-2018 10:03 PM
    • Replies: 11
    • Views: 3,343
    08-27-2018, 01:49 PM Go to last post
  43. C90 Primer layout

    Started by giangab, 08-26-2018 05:26 AM
    • Replies: 4
    • Views: 1,635
    08-26-2018, 02:30 PM Go to last post
  44. Supercub and Mogas

    Started by giangab, 05-24-2018 08:48 AM
    3 Pages
    1 2 3
    • Replies: 84
    • Views: 13,797
    07-30-2018, 10:35 AM Go to last post
  45. 8.00x6.00 Tyre Pressure?

    Started by cubscout, 11-28-2004 10:47 PM
    • Replies: 6
    • Views: 3,866
    07-26-2018, 02:07 AM Go to last post
  46. Aileron pulley bracket

    Started by Billy-250, 07-05-2018 02:38 PM
    • Replies: 4
    • Views: 2,145
    07-07-2018, 03:45 PM Go to last post
  47. Lycoming exhaust oil leak

    Started by bearsnack, 07-14-2005 12:04 AM
    • Replies: 12
    • Views: 7,052
    07-05-2018, 08:15 PM Go to last post

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •