I ordered recently for a "specialized shop" an engine mount to fit a Lyc. O-235L2A on a PA-18 (firewall 18 3/4 - 18 3/8 ). The size of the engine mount is right to fit on the fuselage. But when I test it on my engine that is stocked vertical, nose down bolt on a board. I discovered that low mount point only fit exactly. The two top one do not fit .. mismatch is 1/8 " ??
I have used elastometric engine mount sandwich Lord J-7402 that I get from a Cessna engine mount that fit an O-235.
Help will be welcome because I am unconformable with that story. Engine mount and shipping is expensive and at the end if it does not fit .... ! ''
Thanks for help
Best Regards
Pierre
I have used elastometric engine mount sandwich Lord J-7402 that I get from a Cessna engine mount that fit an O-235.
Help will be welcome because I am unconformable with that story. Engine mount and shipping is expensive and at the end if it does not fit .... ! ''
Thanks for help
Best Regards
Pierre