Activity Stream

Don't believe he has the surface area required to keep the geo field from heating up in a couple of years.

Those are the 8’ Hubble fans you hinted at? About what do they cost per fan?

Alex, are you new to SLC and from WA? Reason I ask is we might have met at UT9 the day I solo’ed

My happy place. But mine’s a toy box, not a tool for work. I have a big shop and no desire to hang out there. Big difference and perhaps a factor to...

Prices have changed but many of the questions I had when we started our hangar are the ones you are considering. First thing I will say though, is...

I'm moving over from a 90hp Cessna 120, which is the nicest flying plane I've ever been in. Much more lively than the super cub on the ground, but...

Last night I remembered a conversation I had years back as we were fighting the compass in a cub, no matter what it would read north due to the...

Here in the Northeast high density foam runs about 80 to 100 cents a board foot installed. 12"x12"x1". In addition to its insulating properties and...

Years ago, we went through a “lightening” program on our heavy Cubs. Lightweight alternators replaced heavy generators (and work better),...

I am very happy with my stick built, sheeted hangar...but I got it done before lumber prices went crazy. I can’t comment on Texas needs but I would...

Safety wire works on the front and rear tubes the same.

I installed the Thrustline mod and I still preferred two turns of nose down trim on landing. After installing the P STOL Flaps I do not need to touch...

You have motivated me to go on a diet. :lol: Weight savings is a never ending deal, it is like crack, you just want more or in this case less. ;)

They seem to have a flat profile at first and then round out over time.

With a little gearing and air pressure certain unicycle opportunities may exist. (Ground Drag induced at normal pressures tend to overcome a rider) ...

It would also be interesting to know the cgs of the 5 cubs and if there was a correlation with aft cgs. I suspect, like always, it’s more about the...

No kidding. Must be nice:-P

Shhhhh don’t tell them that. A 90hp supercub fly’s nice. But a light weight 160 is a dream. pa-11’s,they aren’t that nice to fly. Just kidding. If I...

It's all about compromises. Weight, balance point, performance, safety, convenience, comfort, range and even appearance are interacting factors....

Any interest in selling outright?

Steve, Be happy to help, i do this for a living. My adds are on the calendar. I do the adds just to help out the org. Not because it makes sense,...

Sent from my iPhone using SuperCub.Org mobile app

I’m a big fan of Morton buildings. Incredible insulation, quiet and strong! I heated mine in the Michigan winters for an unbelievable low cost. ...

We don't all have the disposable cash Mr. Ford invested into his cub to make it light... So some ideas and methods that work well. My budget...

Start at the dinner table. Unless your a 120lb guy already, you best dollar to weight reduction is quit eating bread and drinking beer. Sent...

My Dad built his dream hangar a few years ago, 54x60 metal building with a raised center where it looks like a fancy barn w/ 14 ft walls, full slab,...

JIC fittings from a hydraulics shop will work if AN fittings not available. They're 37 deg. The automotive SAE flare is 45 deg. Here's more...

I’m very glad we’re not doing a ground up. MT12 did that for me in 2012 ; ) but it was one of a few whew moments we’ve had doing this deep annual....

Raised by wolves has a very light nice 160 hp 18. Ask him how hard his 3 member gets flying a C90 Pa11 Glenn

If you have never flown any Cub type that is really light you can't understand what a delight a lite Cub is to fly. Not talking take off performance...