Activity Stream

The installation drawing allows the ballast weight to be installed as “an alternate for aircraft loading to obtain weight and balance limits.” In...

What brand power units? I'm guessing Whelen or maybe more likely Aeoflash.

So to confirm, move the power supplies side for side and see if the problem follows the power supply! Sent from my iPhone using Tapatalk

I have not noticed an issue with idle rpm when installed the Sensenich GA prop. Mine is set about 5-600 rpm.

If it works for you then great, but as an FYI Sensenich doesn’t designate pitch the same as on a std metal prop per se. (Their words not mine) As I...

Anyone lose some idle RMPs after installing a Sensenich GA prop? I lost 2-300 RPMs - Enough I had to adjust the idle set screw. I would have...

i cant. I just dont want it to be the power supply🤣.

Use masking tape and a black sharpie to label everything. Label margarine tubs for segregating screws, strut bolts, fairing screws, jury strut...

OK. So explain to me why it can't be the power supply when you have the correct voltage to the power supply and the tube has been tested good on the...

one power supply each side. Power supply was brand new 4 yrs ago so hard for me to believe it is shot.

850 lbs of sand for flight testing. Airworthiness inspection tomorrow Sent from my SM-G965U1 using SuperCub.Org mobile app

No issue with the voltage. Do you have a single power supply for all strobes or do you have one power supply each strobe? As you said earlier,...

Thanks, Ted! I'm just happy to speak ahead of you...you are a tough act to follow on this website! Randy

So is that an issue? The opposite side has similiar readings and it is operating fine.

Can't think of anyone but what model are you looking at?

Pulled it from the mold and did an initial trim. The rest of the cowl will be laid up tomorrow.

Might help to know where they’re located. MTV

He does... he took the picture :) sj

There are a LOT of beautiful places on this planet, along with a LOT of great people. Alaska doesn’t have an exclusive on either.

I think I saw the no vacancy sign at Ted Stevens airport as well as on the way in on the Alcan. I guess the states full. ��

Did you find a resin that is capable of higher temps than west systems? Sent from my iPhone using SuperCub.Org

Flew my buddy home from moose camp.

Back at the project after almost a month off. I did the lay up on the lower cowl and should have the upper sections done this week. Four layers of...

Then stop trying to compete and come on up. Web

Those are good readings, then. Web

Hi Keith, The process of a repair using Stewart Systems is pretty close to what you outlined but a couple differences. I go over repairs as part of...

Well past the statute of limitations: we had a taildragger that had been shot with a thick coat of automobile type catalyzed paint. There were...

Clean it up and carefully pick off any loose or flaking paint. I’d probably use a little rejuvenator to soften up the undercoatings, dab in some...

Have you ever seen the paint detach from the ecobond? Forming a bubble? I wouldn’t have thought the paint was that strong, but it is. Sent from...

If you're using Stewarts to make the repair, use their manual. There is an approved process.