I've said this before and got flamed but that heat shroud design is problematic. My brother managed to get dirt in the end of the heat shroud and it...
If you do have the fuselage 3/8 tubing under the stock battery location, you could use the borer (i think) 1750 gross, drill out the cabane v fitting...
If mine I'd put small drain holes in any low spots....metal shroud or SCAT tubing. Make sure the airbox drains are good to flow water. If it's still...
Is there a Supplement to the Pilot Operating Handbook for the P-Ponk engine conversion on a Cessna 180? Ordering a CGR30P for someone and cannot find...
Hey everyone I have a pretty weird issue happening with my cub. I have a 1976 PA-18 160 HP cub with a pretty new engine only about 250smoh which was...
Thanks Tom. Normally you’d be spot on and I know changing the lighter Cubs to 150HP configuration is kind of a hot button on this forum but this is a...