Activity Stream

It’s overkill until you’re are flying around a congested area where more people than not have their heads down twisting knobs on their video game...

Don't forget that it's the mechanic's name that goes in the logbook. Each individual mechanic has to decide what he considers airworthy. It's just...

I have a 185C project that we took over as a "custom" build that fell flat, has about every combo of light mods I can imagine previously partially...

From the perspective of a Skywagon guy..... 29" Air Hawks on 10" ABW wheels can be run pretty low on pressure with ABW's improved bead. Not Bushwheel...

Yes, change them! I had my bolt that holds the head onto the spring fail while slow taxi. Low time and no rough use. Kurt

Do you have the tabs for the ELT in? DENNY

Do you mean 29" Air Hawks?

No wonder it's hard to get and accurate conversion weight from 31s to 35s. Somewhere between 24 and 38 lbs seems like a big range. Sent from my...

Yep, I agree. I weighed the other un mounted tire and its pretty close to the weight of this one. Did you not put helium in yours Stewart?

Interesting that yours are 6# lighter than mine in the pic on the previous page of this thread.

We just sold an O-200 powered kit built Legend. It was Chris' introduction to Cubs, a nice flying plane. She flew it to Johnson Creek twice and it...

I bought a set of shaved Desser 29's for the 185, took em and left them with my mechanic. He called 20 minutes later and said he couldn't install...

Here’s a 8-9yrld 10” wheel..... There might also be an extra ounce of old bearing grease also. The brake disks on these were pretty wore out...

I noticed that no one brought up the 29x10 airhawks, buffed or standard tread. Seems like those have the some of the same drawbacks as the 26"...

It’s the complete wheel with the brake disk and bearing grease. I had an older set that were slightly heavier. I think the difference is often in the...

No experience on floats. I have a Super Legend that came with the O-233 Lyc 115 hp. Now I have the Titan O-340 on it. There is a story behind the...

The Legend is/has been on my list of possible future purchase for quite some time. Been a big fan since they started producing their 'copy' of the...

I have many hours with the AL3 on both Legend and Baumann floats. Good performer on both land and water. PM me if you have any specific questions.

Thanks for the inside information, Jim. It's very disillusioning to hear that about the Red Cross. I guess I'll have to do something different in...

This was cool too Glenn

Take-off performance (on floats) with my new Catto, as opposed to my old Borer, was a wash. In the air, the Catto was about five mph faster. I like...

Steve, what sizes do you need. I can ship them out today. I can't ship glue but fittings are no problem.

With a brake disc or without? Sent from my SM-G965U1 using SuperCub.Org mobile app

You have an Alaskan Bushwheel tailspring. I use an AN 6-25A bolt with a grade 8 washer on the spring side and an AN363-624 nut to hold the spring to...

"A slip is the result of poor planning" WTF? When you turn final, with a bit of slip required, you can still make the numbers if your engine...