Activity Stream

what Steve said...Yes!

What he said....Abolutely no! People have had a very bad habit of not replacing these tubes at recover or worm gear replacement. A banner plane...

Here's another J5, looks like a pretty decently equipped plane for the money.

Stewart- I’m a staunch believer in powered approach, relatively flat angle of attack (wings slightly aft of horizon), and tail low wheel landings....

I'm curious about the re drilling, too. Will you have access to the tube or does the faa have pics? Web

I have serious doubts that the Whirlwind airboat prop that he's running is going to be a very efficient design or do well at all. Those props are...

https://www.supercub.org/forum/showthread.php?59034-New-piper-j5 Might be worth a look. Fine fun airplanes. Gary

Did it break through the holes? Or somewhere else? If it was somewhere else, the double drilling wasn't the cause.

I’m glad I have friends with helicopters.

To me the question revolves mostly around prop length. I think most folks understand the pitch situation at least on a basic level. Has anyone...

Just a couple weeks ago I looked at a bent project for a friend. A 180 H.P.---18A used for glider towing. Was told the horizontal tube failed during...

65 usd this is a deal 1947 PIPER CUB For Sale in Calgary, Alberta | Controller.com

And, quite a few aviation communities ban helicopters, as does ours near Kenai.

Yes, I believe Paul called it last week. I did a low pass to see how much water was there. Then cruised the lake.

Looks like Alton Bay is done for the year. Kurt

Have you talked with Randy K in Talkeetna? Realtor and member here. He’d likely have some ideas based on fact for ya.

they are leds and use little electricity and come on instantly Sent from my iPhone using SuperCub.Org mobile app

I put these in my shop and am very happy with them Sent from my iPhone using SuperCub.Org mobile app

Flying Sunday around Lake Winni. Alton NH. Overcast and calm winds.

I fought the old leather bindings while marking timber in the winter for years. Then the rubber ones that were junk too. Now I have a pair of the...

Hydraulics shops use JIC fittings because they’re steel. AN fittings are aluminum. I order AN3 or 4 and get steel fittings on the hoses. I’ve had no...

I just ran a sample W&B. If I’m sitting up front, I have 75# of gear in the second seat, 30 gallons of gas, and 500# in cargo? I’m a couple of inches...

Installing slats moves the aft CG limit 1”. This airplane likes weight aft. I keep about 50# of stuff shoved all the way back to make it more...

Oh my goodness! That is crazy good access for a Cub. No more hunking back twisting moose quarters over the rear seat! How’s CG loading range? ...

The thing that tipped the scales for myself when I had the same questions as Johnny. Never mind that it lands so slow.

What ski resort is that and is it open? I see a few tracks I think

It is. It gets complicated if you let it go and the vibration starts taking out other things back there.