Wanted to show how we gained several inches of leg room in our Javron build.
[SUB]Most Super Cub kits are built with the rear seat bottom hinge applied at the same point as the rear seat pan hinge. We placed ours back approximately 5-6inches to provide greater leg room and full range of motion for the control stick when applied. Also modified the removable rear seat top cross brace tube to provide favorable lean back alignment. Keep in mind this will have an effect on rear seat GC station #’s.
[/SUB]
[SUB]Additionally, designed the rear seat back bottom hinge to allow for a flat lay down on the seat pan plywood. This method provides two layers of plywood support.
[/SUB]
[SUB]Just athought.
SHEP
[/SUB]
[SUB]Most Super Cub kits are built with the rear seat bottom hinge applied at the same point as the rear seat pan hinge. We placed ours back approximately 5-6inches to provide greater leg room and full range of motion for the control stick when applied. Also modified the removable rear seat top cross brace tube to provide favorable lean back alignment. Keep in mind this will have an effect on rear seat GC station #’s.
[/SUB]
[SUB]Additionally, designed the rear seat back bottom hinge to allow for a flat lay down on the seat pan plywood. This method provides two layers of plywood support.
[/SUB]
[SUB]Just athought.
SHEP
[/SUB]
Attachments
Last edited: