I spend the last hour reading everything I could find on SC.org about ski's
I have a set of Fed 2000A's I am going to clean up and use on my cub here in Central/Eastern Wa this winter. The bottoms have 1/4" plastic with an alum skeg on them now. I would like to put new UHMW on and would like to extend them out past the edge a bit.
I was wondering how thick and wide I should make the new skeg using UHMW.
Is there a certain amount you can extend the width with out needing approval?
What is the consensus on 3/16" vs' 1/4" thick.