Bugs66
Registered User
Spokane WA
Anyone fabricate their own tank covers and can share any tips and tricks? My left wing is going together somewhat quickly and now I am starting to think about the tank covers.
The Piper drawings show .032 2024 T3. My D&E manual vaguely states .032 6061 T6. On the Piper drawings I see two hat section strips for reinforcement and felt. Would angle section be an acceptable substitute? Looks like nut plates are the way to go for attachment.
Any builder tips anyone can share?
Thanks!
The Piper drawings show .032 2024 T3. My D&E manual vaguely states .032 6061 T6. On the Piper drawings I see two hat section strips for reinforcement and felt. Would angle section be an acceptable substitute? Looks like nut plates are the way to go for attachment.
Any builder tips anyone can share?
Thanks!