Search:

Thank you for the information Jim, It has been mentioned here that a port and polish would do some good... Was this a polish to combustion side for anti knock and improved cooling or suggesting...

there have been quite a few less than experienced metal processors out there. this would be the reason for bad adhesion. Questions to ask your powder coater. Do you blast with virgin AO 80 -100 grit?...

1099510996thanks a ton glenn.....so maybe running 1000 i was thinking 100-200 to offer

I was called by a friend who saw an airplane motor and thought it was an o200 but its not...not sure if it is a 65 or 75hp but the story is that it ran well. Experimental plane no books or...

what about the cam lock latches... I have these in my vette and but have not yet seen them in a plane... The latch is much easier to work and stays out of the way. i dont have to thread all of the...

yep its in ok i was thinking that im going to tx...sorry on that

does anybody have any experience with the rivers moa in ne tx

no doubt they have everything... i am looking to maybe get into it and looking for the inside scoop

Does anybody have experience with the hydrographic or water transfer printing process

So thankful for the news

i remember practicing engine out checklist on the couch eyes closed...only had an engine hiccup over big lake and the muscle memory was still there several years later...id mess up the order...

he is pretty dead on here and I didn't know how to say it nicely...you are probably at hr 7 and possibly being asked too much...

I began in a c152 and then moved to an alarus....low wing reclined...

That is exactly the way we plan for the dogs getting baths at my current place of employment....

Here is something i posted before without much discussion Ill try again


Same car that i posted about in the suspension forum. Propane chevelle engineered by Johnny O.... ...

maybe their punishment should be purchasing one set of 35 in bushwheels for any folks that fly in the area and would have liked to use the strip

I had flown into ANE a couple of times and had no idea that the museum was there...this last trip i made Sherpa was in the corner and i pretty much fell in love with it then.. I love the interiors in...

did you use the 3gi on this plane or did you find any noticeable improvements worth the weight

where is the thread i searched uav dji and quadcopter

i just had doubler put on mine in the drain and feed areas...welder here charged $40

Im a huge fan of the drone. I really enjoyed the last couple video i saw ....keep it going...the voice over was fine...what do you use to get the rotating tripod shot

exp

it is a small c85 and the lights work well enough to find grass between taxiways with out a lit airport...they are fairly impressive but i will be looking for some led's that have a germanium...

what speed are the fixed wing models ...can we even run them down...

i bet that we could get it passed that they must carry a horn to signal before change of direction...the folks that put them...

no its not our fault they will just blame us