Regarding drawings - The bracket is fabricated by Vans (the kit manufacturers of the RV kitplane), you could contact them for a drawing. Last time I checked, the brackets were inexpensive (check out...
Type: Posts; User: Clark
Regarding drawings - The bracket is fabricated by Vans (the kit manufacturers of the RV kitplane), you could contact them for a drawing. Last time I checked, the brackets were inexpensive (check out...
Hi grdev
The Van's Bracket is 0.060" thick
You are welcome Bushcaddy. I had to modify the Van's Bracket for my mixture - I have altered the mixture again (see photos), as I didn't like the big tight curve I had in the mixture cable. Now it...
Hello Bushcaddy - It is 12 inches from my firewall to my aft carb/sump bolt (a couple of photos attached). I have a solid wire to my mixture (I find this application a little on the stiff side - but...
So here are some updated photos of my mixture cable install. I plan on replacing the rubber adel with a AN742 plain metal clamp.565856595660
Hi Don
You & I must think the same. I have been flying my RV7 since 2006 & I am now building a "Turbine" Backcountry Super Cub. I really surprised myself with this choice as I have always...
Hi Kirk
Yes, that is correct - I have cut off the last few inches of the bracket (the end that holds a mixture cable). If you look closely at the photo you will see a tiny black dot near the end...
Im very new at these websites - here is the website link for the Van's bracket
http://www.vansaircraft.com/cgi-bin/catalog.cgi?ident=1329924985-218-300&browse=controls&product=throttle-bracket
Hi Mike
Van's Aircraft does make these & they are not expensive. All I did is purchase one & perfromed a 30 minuite modification of cutting off the back few inches to achieve clearance for my FWF...
Just wanted to update the Van's Bracket idea for the throttle & mixture cable mounting (to engine - not engine mount). I had to modify - Cut off the rear section of this bracket to clear the cabin...
Hi Rick
Yes the Van's Bracket fits my O-360. The total length of the bracket is about 12" (see attached photo). With my setup that leaves about 2 1/2" between the end of the Bracket & the...
41334134 This is what the Van's Bracket looks like. The attached photos are showing the top surface that fits up against the sump & the carb fits on the underside (gaskests on both sides). This...
