• jimboflying's Avatar
    06-02-2013, 11:31 PM
    These are big VMN7 Bendix mags. The P-lead wire has braided shielding around it which is connected to the big nut on the back of the mag. The P lead...
    16 replies | 656 view(s)
  • jimboflying's Avatar
    06-02-2013, 10:38 PM
    Are you saying that they should be grounded to the firewall ground lugs instead?
    16 replies | 656 view(s)
  • jimboflying's Avatar
    06-02-2013, 10:34 PM
    Mike, I do have that grounding wire in place and I have tested it for continuity. What I was trying to say is that the P lead shielding is only...
    16 replies | 656 view(s)
  • jimboflying's Avatar
    06-02-2013, 07:22 PM
    I spoke too soon. The problem returned as soon as I got close to an airport that uses 122.8. Other frequencies such as 118.2,121.8, and 135.425 work...
    16 replies | 656 view(s)
  • jimboflying's Avatar
    06-01-2013, 10:34 PM
    You might try a google search for Faust PA12 and you will find quite a few pictures of it over the years. It spent over 20 years in Alaska before I...
    16 replies | 656 view(s)
  • jimboflying's Avatar
    06-01-2013, 09:06 PM
    I checked the engine to firewall nut stud grounding strap and it was good. I then checked all the plug wires. I found two places where the covering...
    16 replies | 656 view(s)
  • jimboflying's Avatar
    05-31-2013, 10:48 PM
    I am hearing intermittent popping crackling sounds on the radio. The strange part is that if I turn the mag switch from both to left the noise goes...
    16 replies | 656 view(s)
  • jimboflying's Avatar
    05-29-2013, 10:09 PM
    I have used wood for fairings in the past but decided to try something different to learn a new technique. What I came up with is called a closed...
    131 replies | 4104 view(s)
  • jimboflying's Avatar
    05-29-2013, 05:34 PM
    I did the low tech method of sticking a faired and unfaired round tube out of the car window going down the highway at a legal 75mph. The results...
    131 replies | 4104 view(s)
  • jimboflying's Avatar
    05-28-2013, 10:29 PM
    I decided to make some carbon fiber trailing edge fairings with a closed mold technique. They are very light weight and are meant to be bonded to the...
    131 replies | 4104 view(s)
No More Results
About jimboflying

Basic Information

Statistics


Total Posts
Total Posts
254
Posts Per Day
0.09
General Information
Last Activity
Yesterday 08:24 PM
Join Date
05-05-2005

Classifieds Statistics

Statistics

Number of Ads
2
Number of Comments
0
Number of times products viewed
739
Last Ad Uploaded

mccauley-wheel-center-section
Last Comment Posted
Never
FeedBack
Post Seller Feedback