Page 1 of 27 12311 ... LastLast
Threads 1 to 50 of 1346

Forum: Tips and Tricks

Little (and big) Tidbits for your Cub

  1. tools, jigs, fixtures, and other neat stuff

    Started by mike mcs repair, 09-04-2010 01:58 PM
    15 Pages
    1 2 3 ... 15
    • Replies: 588
    • Views: 253,771
    Yesterday, 06:42 PM Go to last post
  2. Aileron pulley bracket

    Started by Billy-250, 07-05-2018 02:38 PM
    • Replies: 4
    • Views: 499
    07-07-2018, 03:45 PM Go to last post
  3. Lycoming exhaust oil leak

    Started by bearsnack, 07-14-2005 12:04 AM
    • Replies: 12
    • Views: 4,407
    07-05-2018, 08:15 PM Go to last post
  4. Supercub and Mogas

    Started by giangab, 05-24-2018 08:48 AM
    3 Pages
    1 2 3
    • Replies: 81
    • Views: 4,340
    06-01-2018, 07:57 AM Go to last post
  5. removing shock cords from PA-12

    Started by Larry Huntley, 05-15-2018 09:01 AM
    • Replies: 26
    • Views: 2,064
    05-29-2018, 03:38 PM Go to last post
  6. Another why not to use ethanol gas

    Started by Doug Budd, 06-30-2017 08:51 AM
    • Replies: 7
    • Views: 2,065
    05-26-2018, 03:04 PM Go to last post
  7. New spar flap hinges

    Started by Tango Cub, 05-22-2018 04:22 PM
    • Replies: 8
    • Views: 769
    05-23-2018, 11:25 AM Go to last post
    • Replies: 5
    • Views: 784
    05-14-2018, 09:25 AM Go to last post
  8. Bungee Covers

    Started by Steve Pierce, 05-12-2018 05:41 PM
    • Replies: 1
    • Views: 606
    05-13-2018, 08:49 AM Go to last post
  9. prop rpm

    Started by skybolt64, 02-17-2016 08:45 PM
    • Replies: 29
    • Views: 8,152
    05-06-2018, 02:18 PM Go to last post
  10. Midgies stuck on my final paint surface

    Started by ron, 05-03-2018 03:10 AM
    • Replies: 1
    • Views: 528
    05-03-2018, 04:52 AM Go to last post
  11. Bushwheel Obstructed Valve

    Started by stewartb, 04-27-2018 07:49 AM
    • Replies: 4
    • Views: 821
    04-28-2018, 07:07 AM Go to last post
    • Replies: 23
    • Views: 1,457
    04-22-2018, 12:01 AM Go to last post
  12. 3 inch gear question

    Started by Beaverpilot, 04-02-2018 02:53 PM
    • Replies: 18
    • Views: 2,516
    04-14-2018, 11:19 AM Go to last post
  13. Which fuel tank to select for T.O. and Landings?

    Started by supercub, 06-27-2003 09:35 PM
    2 Pages
    1 2
    • Replies: 62
    • Views: 9,083
    04-13-2018, 06:13 AM Go to last post
    • Replies: 15
    • Views: 5,548
    04-02-2018, 06:35 AM Go to last post
  14. Cub Rudder Pedal Friction..how much is too much?

    Started by bsantana, 02-22-2006 01:05 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 8,504
    03-31-2018, 09:35 AM Go to last post
  15. Changing tailwheel tire

    Started by Jr.CubBuilder, 12-14-2007 12:03 AM
    • Replies: 34
    • Views: 4,631
    03-29-2018, 03:18 PM Go to last post
  16. Supercub headliner

    Started by giangab, 03-20-2018 05:18 PM
    • Replies: 5
    • Views: 1,000
    03-26-2018, 01:17 AM Go to last post
  17. How NOT to land and take off in a cross wind

    Started by Doug Budd, 03-17-2018 10:34 AM
    • Replies: 7
    • Views: 1,718
    03-18-2018, 09:01 PM Go to last post
  18. Post Engine Mount with 0 degrees with trust line

    Started by carlbrun, 03-15-2018 12:05 PM
    • Replies: 4
    • Views: 989
    03-16-2018, 07:28 PM Go to last post
  19. Piper channel above birdcage location?

    Started by jrussl, 11-14-2010 12:38 PM
    • Replies: 17
    • Views: 6,838
    03-15-2018, 03:06 PM Go to last post
  20. CAD Plated Parts, How to Prime and Paint?

    Started by Steve Pierce, 12-08-2012 09:38 AM
    • Replies: 12
    • Views: 4,012
    03-13-2018, 05:23 PM Go to last post
    • Replies: 8
    • Views: 1,054
    03-11-2018, 10:01 PM Go to last post
  21. Backcountry Engine Preheat

    Started by Cub Special Ed, 10-15-2017 03:36 PM
    3 Pages
    1 2 3
    • Replies: 97
    • Views: 10,859
    03-11-2018, 08:17 PM Go to last post
    • Replies: 2
    • Views: 780
    03-04-2018, 02:01 AM Go to last post
  22. Welding rod question

    Started by Beaverpilot, 02-01-2018 01:08 AM
    • Replies: 29
    • Views: 2,826
    02-25-2018, 09:27 AM Go to last post
  23. Cad cam

    Started by jimboflying, 02-04-2018 10:49 PM
    • Replies: 4
    • Views: 895
    02-08-2018, 08:48 PM Go to last post
  24. Fuel Injection Engine Starting

    Started by stewartb, 02-04-2018 09:16 PM
    • Replies: 9
    • Views: 953
    02-05-2018, 10:50 AM Go to last post
  25. Good Screwdriver Tips

    Started by robertc, 01-27-2018 02:18 PM
    • Replies: 21
    • Views: 2,445
    02-01-2018, 07:27 PM Go to last post
  26. Rivet pitch ?

    Started by Beaverpilot, 01-18-2018 01:31 AM
    • Replies: 17
    • Views: 1,705
    01-22-2018, 08:14 PM Go to last post
  27. Low speed airspeed indicator

    Started by wheatjp, 01-13-2018 10:30 PM
    2 Pages
    1 2
    • Replies: 41
    • Views: 3,211
    01-17-2018, 05:48 PM Go to last post
  28. How to not mess this up?

    Started by Beaverpilot, 01-15-2018 04:47 PM
    • Replies: 6
    • Views: 1,580
    01-16-2018, 08:38 PM Go to last post
  29. Propeller Paint

    Started by Helmetfire, 11-14-2017 09:51 PM
    • Replies: 22
    • Views: 2,883
    12-19-2017, 05:57 PM Go to last post
  30. Tail Pedestal. Pireps?

    Started by stewartb, 12-11-2017 09:53 PM
    • Replies: 3
    • Views: 1,336
    12-12-2017, 01:40 PM Go to last post
  31. Oiling Fuselage Tubes

    Started by markc, 05-12-2004 07:32 PM
    2 Pages
    1 2
    • Replies: 49
    • Views: 10,714
    12-11-2017, 07:33 AM Go to last post
  32. Playing with the 3D printer...again

    Started by Weasel, 11-02-2017 07:27 PM
    • Replies: 13
    • Views: 1,823
    12-09-2017, 09:50 AM Go to last post
  33. trim indicator stuck

    Started by vj88, 07-12-2017 12:29 PM
    • Replies: 11
    • Views: 2,686
    12-05-2017, 04:35 AM Go to last post
  34. How to rebuild a tailwheel

    Started by Bill Rusk, 01-03-2011 03:34 PM
    • Replies: 30
    • Views: 22,029
    11-28-2017, 10:37 AM Go to last post
  35. Cold oil temp fix needed

    Started by N4263M, 11-20-2017 06:45 AM
    • Replies: 22
    • Views: 2,637
    11-27-2017, 09:21 AM Go to last post
  36. Keller (Perfromance) Flap question. Needing more tension some how??

    Started by Aktahoe, 07-01-2016 10:10 AM
    3 Pages
    1 2 3
    • Replies: 100
    • Views: 23,208
    11-06-2017, 07:55 PM Go to last post
  37. Battery position PA18-95

    Started by giangab, 10-29-2017 12:55 PM
    • Replies: 9
    • Views: 1,489
    10-30-2017, 10:00 AM Go to last post
  38. DA performance how to calculate T/O roll

    Started by Colorguns, 10-26-2017 06:49 PM
    • Replies: 9
    • Views: 1,750
    10-29-2017, 10:40 AM Go to last post
  39. PA18 wing fuselage rigging

    Started by giangab, 10-14-2017 03:34 AM
    • Replies: 19
    • Views: 2,468
    10-23-2017, 06:50 AM Go to last post
  40. 200 rpm Mag drop Bendix left mag

    Started by floatpilot, 07-23-2017 08:08 PM
    2 Pages
    1 2
    • Replies: 47
    • Views: 6,217
    10-10-2017, 11:26 AM Go to last post
  41. carrying dogs in a Cub

    Started by JMBreitinger, 06-29-2004 11:41 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 145
    • Views: 33,022
    09-29-2017, 10:34 PM Go to last post
  42. Scott 3200 Taiwheel refurbishment

    Started by Binty, 05-15-2011 03:12 AM
    2 Pages
    1 2
    • Replies: 56
    • Views: 23,614
    09-08-2017, 08:00 PM Go to last post
  43. Trim crank handle removal?

    Started by Oliver, 11-15-2014 11:58 PM
    • Replies: 35
    • Views: 10,881
    09-05-2017, 12:54 PM Go to last post
  44. J3 - Left window slider

    Started by Lancer, 09-03-2017 07:25 PM
    • Replies: 2
    • Views: 1,320
    09-04-2017, 07:28 PM Go to last post
  45. Wing tank sight glass mounting

    Started by Lancer, 08-13-2017 03:39 PM
    • Replies: 23
    • Views: 2,883
    09-03-2017, 07:22 PM Go to last post

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •