Page 1 of 31 12311 ... LastLast
Threads 1 to 50 of 1533

Forum: Super Cub Sick Bay

Got problems with your cub? Other friendly folks may be able to offer you some advice!

  1. Sticky Thread Sticky: How Not To Do It

    Started by Steve Pierce, 06-18-2014 07:26 AM
    • Replies: 12
    • Views: 6,234
    07-12-2014, 12:36 PM Go to last post
  2. Sticky Thread Sticky: Slick Magneto Service Bulletin.

    Started by Steve Pierce, 06-16-2008 09:39 PM
    • Replies: 35
    • Views: 22,845
    09-19-2008, 09:45 AM Go to last post
  3. Sticky Thread Sticky: Smith/Turbine Cub Wing Attach Fitting Alert!

    Started by Steve Pierce, 04-05-2008 09:51 AM
    • Replies: 17
    • Views: 11,668
    04-16-2008, 03:32 PM Go to last post
  1. Bucking bar for flap leading edge rivets

    Started by kiwicubber, Yesterday 02:57 AM
    • Replies: 7
    • Views: 346
    Yesterday, 03:46 PM Go to last post
    • Replies: 6
    • Views: 385
    08-17-2017, 02:56 PM Go to last post
  2. Oil line corrosion: suggestions

    Started by BritishCubBloke, 08-15-2017 09:32 PM
    • Replies: 9
    • Views: 414
    08-17-2017, 05:58 AM Go to last post
  3. Flat Tire Woes

    Started by WindOnHisNose, 08-06-2017 11:22 AM
    • Replies: 7
    • Views: 1,073
    08-09-2017, 06:31 AM Go to last post
  4. Re-use or replace engine hardware?

    Started by Helmetfire, 07-31-2017 02:47 PM
    • Replies: 18
    • Views: 1,099
    08-01-2017, 05:51 PM Go to last post
  5. engine mounts

    Started by Oliver, 07-28-2017 10:32 PM
    • Replies: 8
    • Views: 796
    08-01-2017, 05:05 AM Go to last post
  6. Oil cooler return blockage

    Started by Helmetfire, 07-09-2017 10:03 PM
    • Replies: 11
    • Views: 1,173
    07-31-2017, 03:03 PM Go to last post
  7. Wing recover

    Started by jimboflying, 06-28-2017 09:22 PM
    • Replies: 22
    • Views: 2,663
    07-19-2017, 11:11 AM Go to last post
  8. Engine Runs (Ran) Hot

    Started by WindOnHisNose, 07-14-2017 10:23 PM
    • Replies: 30
    • Views: 1,721
    07-17-2017, 10:48 AM Go to last post
  9. Setting Wing Dihedral Using a Digital Level

    Started by KJC, 07-07-2017 08:27 PM
    • Replies: 30
    • Views: 1,662
    07-10-2017, 01:51 PM Go to last post
  10. Fuel Stain mystery.

    Started by cubpilot2, 06-09-2016 01:20 AM
    • Replies: 26
    • Views: 4,834
    07-10-2017, 04:36 AM Go to last post
  11. Seized bolt in Scott tailwheel

    Started by Marty57, 07-01-2017 07:46 PM
    • Replies: 12
    • Views: 957
    07-04-2017, 05:04 PM Go to last post
  12. Are We Too Picky or What?

    Started by Steve Pierce, 06-06-2017 07:41 AM
    • Replies: 39
    • Views: 4,048
    06-29-2017, 12:19 AM Go to last post
  13. Brake bleeding

    Started by willirw, 04-26-2012 10:29 PM
    • Replies: 18
    • Views: 6,468
    06-18-2017, 12:20 PM Go to last post
  14. Tail wheel Problems

    Started by Herc, 06-13-2017 10:50 AM
    • Replies: 8
    • Views: 930
    06-13-2017, 12:32 PM Go to last post
  15. videoscopes

    Started by larrym, 12-27-2011 04:38 PM
    • Replies: 24
    • Views: 2,844
    06-10-2017, 01:07 PM Go to last post
  16. Oil temperature question

    Started by CamTom12, 11-16-2016 08:33 AM
    2 Pages
    1 2
    • Replies: 68
    • Views: 10,769
    06-04-2017, 04:51 PM Go to last post
  17. paint gun recommendation

    Started by vj88, 05-28-2017 10:05 AM
    • Replies: 23
    • Views: 2,285
    06-04-2017, 02:08 PM Go to last post
  18. Step Corrosion, Powder Coat?

    Started by Steve Pierce, 06-04-2017 08:18 AM
    • Replies: 3
    • Views: 654
    06-04-2017, 01:07 PM Go to last post
  19. Temperature and Pressure Ranges

    Started by Hendoii, 06-02-2017 03:29 PM
    • Replies: 4
    • Views: 686
    06-02-2017, 09:08 PM Go to last post
  20. Question WTF is this little cable ?

    Started by Naaalex, 05-24-2017 04:07 PM
    • Replies: 7
    • Views: 1,313
    05-25-2017, 05:07 AM Go to last post
  21. C-90 Cylinders

    Started by RaisedByWolves, 01-08-2017 07:12 PM
    • Replies: 14
    • Views: 2,638
    05-15-2017, 07:33 AM Go to last post
  22. Lycoming O-235 will not run above 1500RPM

    Started by txfirefighter628, 10-14-2016 11:12 AM
    2 Pages
    1 2
    • Replies: 54
    • Views: 7,989
    05-12-2017, 08:19 AM Go to last post
    • Replies: 3
    • Views: 607
    05-11-2017, 11:00 PM Go to last post
  23. Lycoming O235 Continuous burnt Valve problems

    Started by Fortysix12, 08-10-2010 09:33 AM
    • Replies: 16
    • Views: 8,689
    05-10-2017, 09:11 PM Go to last post
    • Replies: 2
    • Views: 738
    05-09-2017, 11:42 PM Go to last post
  24. Rigging/Stick Travel Question

    Started by Hendoii, 05-07-2017 10:26 AM
    • Replies: 5
    • Views: 701
    05-07-2017, 02:00 PM Go to last post
  25. Propeller Ballancing

    Started by Hood River 5, 02-09-2013 02:20 PM
    • Replies: 17
    • Views: 4,607
    04-25-2017, 09:18 PM Go to last post
  26. Gasket needed

    Started by flyrite, 04-16-2017 06:50 PM
    • Replies: 3
    • Views: 822
    04-18-2017, 11:51 AM Go to last post
  27. Tailwheel Shimmy

    Started by SJ, 03-18-2002 08:47 AM
    2 Pages
    1 2
    • Replies: 72
    • Views: 21,826
    04-15-2017, 06:43 AM Go to last post
  28. Rubber Hose VS AN Fittings

    Started by Hendoii, 04-06-2017 09:25 AM
    • Replies: 10
    • Views: 1,772
    04-08-2017, 10:27 AM Go to last post
  29. PA-18A Battery

    Started by kiwicubber, 03-31-2017 02:12 AM
    • Replies: 9
    • Views: 1,769
    04-06-2017, 12:42 AM Go to last post
  30. Starter and Battery Contactor

    Started by Hendoii, 03-31-2017 09:28 PM
    • Replies: 20
    • Views: 2,471
    04-04-2017, 10:05 PM Go to last post
  31. C-90 gets tight when warm

    Started by old cub pilot, 04-01-2017 08:59 AM
    • Replies: 9
    • Views: 1,350
    04-02-2017, 03:11 PM Go to last post
  32. Cessna 206 flap question

    Started by Jack Smith, 03-28-2017 01:58 AM
    • Replies: 5
    • Views: 920
    03-28-2017, 11:36 PM Go to last post
  33. Cowling (Building your Own)

    Started by Hendoii, 03-21-2017 04:54 PM
    • Replies: 19
    • Views: 2,559
    03-22-2017, 01:56 PM Go to last post
  34. PA12 tail spring and small shimmy on our 3200 tailwheel

    Started by C130jake, 03-05-2017 07:54 PM
    2 Pages
    1 2
    • Replies: 60
    • Views: 5,214
    03-16-2017, 04:12 PM Go to last post
  35. belt squeals upon starting

    Started by dtmnm25, 03-13-2017 09:20 PM
    • Replies: 16
    • Views: 1,394
    03-15-2017, 01:09 AM Go to last post
  36. CHT 's

    Started by cubtime, 06-04-2014 04:58 PM
    2 Pages
    1 2
    • Replies: 43
    • Views: 11,345
    03-03-2017, 09:45 AM Go to last post
  37. Super Cub Hardware Kit

    Started by mikeo, 01-29-2006 06:48 PM
    • Replies: 32
    • Views: 9,831
    02-20-2017, 06:43 AM Go to last post
  38. magneto grounding

    Started by Jack Smith, 02-17-2017 03:00 AM
    grounding, magneto
    • Replies: 24
    • Views: 2,246
    02-19-2017, 02:32 PM Go to last post
  39. Slick 4201 and 4301, educate me

    Started by zenairdave, 02-15-2017 11:10 AM
    • Replies: 2
    • Views: 676
    02-15-2017, 02:21 PM Go to last post
  40. High oil temp adding oil cooler

    Started by Jack Smith, 02-11-2017 01:11 PM
    high oil temp, oil cooler, oil temp
    • Replies: 19
    • Views: 2,039
    02-13-2017, 09:48 AM Go to last post
  41. Check That Muffler

    Started by Steve Pierce, 12-16-2010 11:02 PM
    2 Pages
    1 2
    • Replies: 69
    • Views: 20,507
    02-02-2017, 06:10 PM Go to last post
  42. Can cable drive tachs be re-calibrated???

    Started by Alex Clark, 02-01-2017 03:35 PM
    • Replies: 8
    • Views: 1,210
    02-02-2017, 12:33 PM Go to last post
  43. Rivets in Belly pulling

    Started by vj88, 01-30-2017 03:10 PM
    • Replies: 16
    • Views: 1,709
    02-01-2017, 02:39 PM Go to last post
  44. Push Pull Cables

    Started by Eddie Foy, 12-20-2015 07:13 AM
    • Replies: 18
    • Views: 3,583
    01-31-2017, 09:40 AM Go to last post
  45. Wavy Spine

    Started by Hendoii, 01-28-2017 04:30 PM
    • Replies: 14
    • Views: 2,250
    01-31-2017, 06:15 AM Go to last post
  46. ma3spa carb

    Started by swoeric, 10-08-2011 11:20 PM
    2 Pages
    1 2
    • Replies: 40
    • Views: 12,533
    01-30-2017, 04:05 PM Go to last post
    • Replies: 30
    • Views: 3,196
    01-22-2017, 07:49 PM Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •