Need some advice from some of you knowledgeable people:
Busy with an experimental build, PA-18, and managed to find a pair of brake assemblies on E-bay.
I notice the one set (LHS) does not have the threaded fitting on the front for the Scott 4200 park brake valve to screw into.
Should I just drill out and weld on a nut to the the front of the brake where the park brake should screw in.
Out of interest, would these brake assemblies possible have come from a different type of cub that didn't use a park brake, or only used them on the one side?
I have attached the picture of the brake assemblies as well as drawing 13399 which shows the brake Installation.
Thank you,
Neal.
Busy with an experimental build, PA-18, and managed to find a pair of brake assemblies on E-bay.
I notice the one set (LHS) does not have the threaded fitting on the front for the Scott 4200 park brake valve to screw into.
Should I just drill out and weld on a nut to the the front of the brake where the park brake should screw in.
Out of interest, would these brake assemblies possible have come from a different type of cub that didn't use a park brake, or only used them on the one side?
I have attached the picture of the brake assemblies as well as drawing 13399 which shows the brake Installation.
Thank you,
Neal.