I am in the process of installing the landing gear.
When I measure the distance from the center of the tail post to the outer end of the axles, I have 3/16" more from the center of the tail post to the outside of the left axle than I do from the center of the tailpost to the outside end of the right axle.
The attach fitting are only tack welded at this point.
I am not sure I can correct this without putting somethingin a bind.
How critical is this? Should I rework the fittings to try to get this the same?
I am open to suggestions.
Thank you;
Mark
When I measure the distance from the center of the tail post to the outer end of the axles, I have 3/16" more from the center of the tail post to the outside of the left axle than I do from the center of the tailpost to the outside end of the right axle.
The attach fitting are only tack welded at this point.
I am not sure I can correct this without putting somethingin a bind.
How critical is this? Should I rework the fittings to try to get this the same?
I am open to suggestions.
Thank you;
Mark