I am building an SQ2. The instructions state that I should bend the stringers so that they don't touch the frame tubes that don't have a bracket. Also, it doesn't say how much clearance is needed.
They suggest that I remove some metal from the stringer so that it can be bent enough to make a turn around the frame at one specific spot.
My questions:
Is it OK to notch out a stringer so that it clears the frame?
How much clearance is needed?
They suggest that I remove some metal from the stringer so that it can be bent enough to make a turn around the frame at one specific spot.
My questions:
Is it OK to notch out a stringer so that it clears the frame?
How much clearance is needed?